Troubleshooting Passenger Side Trailer Turn Signal And Brake Light Not Working On 2019 Ram 1500

Question

Question:

Right side trailer signal and brake wire has no power

asked by: Chuck

0

Expert Reply:

Since the passenger side trailer turn signal and brake light has no power on your 2019 Ram 1500 I recommend checking fuse F81 in the engine bay fuse box as this is the fuse for just the passenger side turn signal and brake light. It should be a 20 amp yellow fuse.

If it is blown or missing you will need to replace it with a 20 amp micro fuse.

I included a link to a helpful article on wiring for you to take a look at.

expert reply by: Samuel C

0

Answer 1

If you are experiencing a "trailer disconnect" error message, the most common reason for this is a rusty/corroded trailer connection between the tow vehicle and the trailer. In order to rule out this possibility, I recommend…

view full answer...

Answer 2

There are several items you might want to try using for removal of corrosion in your 7-way trailer connector, like part #HM48480. White Vinegar A wedge shaped, slip on pencil eraser or art gum eraser Pipe cleaners PB Blaster If the corrosion is…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...