Difference Between EZ Connector 7-Way Gooseneck Kits 319-S7-09D and 319-S7-09

Question

Question:

On the EZ connector there are two models that appear to be the same. What is the difference between 319-S7-09 and 319-S7-09D Thank you

asked by: Hugh L

0

Expert Reply:

The difference between the two EZ Connectors is the trucks they fit. The # 319-S7-09D has the square connector found exclusively on Ram trucks from a specific year range whereas the part # 319-S7-09 uses the standard round 7-way connector which fits most trucks on the road. Since I believe you have a 2020 Ford F-350 this would be what you'd want.

expert reply by: Jameson C

0

Answer 1

I have seen this with all of the Goose Neck Ball Kits like the B&W Ball and Safety Chain Kit part #BWGNXA2061 when the are left permanently installed and subjected to the elements. Not only is it common with these but also all of the goose neck…

view full answer...

Answer 2

We have the EZ Connector #319-S7-06 which is designed to fit the standard 4-bolt 7-way mounting flanges which would be the easiest fit to replace the 7-way of your 2019 Ram 3500. Then for your trailer side 7-way you'd want the EZ Connector…

view full answer...

Answer 3

I do have a solution, but there is not an adapter that would allow you to replace the OEM connection and keep the factory look on your 2020 Tundra. Since nothing will match that cutout, I have two options that will allow you to use the EZ Connector…

view full answer...

Answer 4

The thickness of the mounting plate on the Tow Ready #63056 Pintle Hook Mount is 5/8".

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Difference Between EZ Connector 7-Way Gooseneck Kits 319-S7-09D and 319-S7-09

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching