Inexpensive Corrosion Resistant Disc Trailer Brakes for Salt Water Use and a Boat Trailer

Question

Question:

I PUT MY BOAT IN SALT WATER A LOT AND WANT TO KNOW WITCH BRAKES ARE GOOD WITH OUT BRAKING THE BANK. I HAVE DIS BRAKES 15inch WHEEL 51/2-6

asked by: PAUL

1

Helpful Expert Reply:

The best possible material for saltwater applications is going to be stainless steel but since cost is a factor stainless would not be the way you would want to go.

The next best thing is going to be a brake kit with Dacromet finish like # K2R526D. The Dacromet has a 400 to 600 salt spray rating but it is always a good idea to spray them of with fresh water after use in salt water.

This kit is designed to fit over idler hubs with a 6 on 5-1/2 bolt pattern and 15 inch or larger wheels on 5,200 to 6,000 pound axles. I have included a link to the installation instructions for you to view.

expert reply by: Michael H

1

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 3

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

view full answer...

Answer 4

Leaf springs typically have the part #stamped on the strap that holds the leafs together at one end of the shorter leafs, or it is painted on the concave side of the springs. The part number can then be used to determine the capacity of the springs.…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 7

Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.

view full answer...

Answer 8

The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for a…

view full answer...

Answer 9

As long as the weight capacity is inline with your trailer/axle rating and the measurements match your current springs, the number of leaves in a spring pack does not matter. The difference between a 3 and 4 leaf spring pack within the same weight…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 12

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Inexpensive Corrosion Resistant Disc Trailer Brakes for Salt Water Use and a Boat Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching