Landing Pads for the Yakima Tracks

Question

Question:

I bought a new truck, put a camper shell in the back with strips on top to mount yakima canoe rack. I have bars and locking towers but need the part that attaches to the strip. I dont see it on you site. It is the part the tower sits in

asked by: Julian C

0

Expert Reply:

If you have Yakima tracks like part # Y01135, these accept the Yakima Landing Pad 1, part # Y00221. These connect to the Yakima Control Towers. They come in a pack of 2, so for two bars you will need to get two of these (to make 4).

If you have different towers or tracks, let me know and I will help you find what you need.

expert reply by: Kef G

0

Answer 1

You'll be able to use almost any replacement strip as they are almost always fit for a 3/8 inch channel. I specifically recommend the Thule Replacement Channel Cover 59 inch, part #852-5402-005 or the Rhino Rack Vortex 15-3/4, part #RRM626. These…

view full answer...

Answer 2

As long as the crossbars you use aren't wider than the widest part of the vehicle (usually the mirrors), which could be a safety problem or even illegal in some areas, you could certainly use longer crossbars than the 58 inch crossbars. Since…

view full answer...

Answer 3

The Yakima Replacement Anchor Plate Style-A, Part #Y8810074, comes as a set of 8 plates that measure 3/4-inch x 7/8-inch. The centered threaded hole measures 0.2 inches (or 5.1 millimeters) in diameter. Please refer to the photo provided. The Yakima…

view full answer...

Answer 4

Yes, the tracks themselves recreate the factory C-shaped rack tracks. Thule Tracks #THTP42 and Yakima Tracks #Y01126 have the same C-channel design, but differ in length and how they mount to the vehicle. To use your SkyLine Towers #Y53TR with these…

view full answer...

Answer 5

The benefit to a non-powered trailer wiring harness is that it's a bit easier to install since you don't have to run a wire up to the battery of the vehicle. The advantage to a powered kit is that it does a better job protecting the taillight…

view full answer...

Answer 6

Thank you for your recent purchase of hitch receiver and wiring harness from etrailer. The Curt Wiring Harness #56146KIT is a correct fit for your 2013 Sienna. Thank you for submitting your two photos. This trailer wiring harness installs primarily…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Landing Pads for the Yakima Tracks

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching