Pilot Inner Diameter for Derale Thermal Fan Clutch D22140

Question

Question:

I am trying to get information on your fan clutch part No. D22140, all the information is great and very detailed, however i dont see one measurement, Im trying to confirm the I.D. pilot that connects to my water pump is 5/8? GM made two different water pumps and fan clutches one with a 3/4 pilot the other with a 5/8 pilot. thank you

asked by: Joseph G

0

Expert Reply:

I reached out to Derale, who as able to confirm for me that the pilot inner diameter was 5/8 inches of the Derale Thermal Fan Clutch with Reverse Rotation # D22140.

expert reply by: Kyle S

0

Answer 1

In regards to the Derale Thermal Fan Clutch with Reverse Rotation part #D22140, the distance from the mounting surface to the end of the shaft is 1-13/16" and the distance from the mounting surface to the end of the clutch is 1-3/4". I went…

view full answer...

Answer 2

It sounds like you may have a connector on your truck bed camper that's similar to a hookup for a dryer. If that's the case we definitely don't have any adapters for it and you'll likely have a hard time finding one so rewiring it to…

view full answer...

Answer 3

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Pilot Inner Diameter for Derale Thermal Fan Clutch D22140

Product Page this Question was Asked From

Continue Researching