Do The Torklift Camper Tiedowns Come With Both The Front And Rear Set For The 2017 GMC Sierra 3500

Question

Question:

do you get both the front and rear 1010.98

asked by: David

1

Helpful Expert Reply:

The TorkLift Talon Custom Frame-Mounted Camper Tie-Downs - Aluminum - Front Item # TLC2214A is only going to be for the front of your 2017 GMC Sierra 3500. For the rear you would want tot use the TorkLift Talon Custom Frame-Mounted Camper Tie-Downs - Aluminum - Rear Item # TLC3217A.

expert reply by: Shane H

1

Answer 1

I recommend using the TorkLift Custom Frame-Mounted Camper Tie-Downs for a 2019 Chevrolet Silverado 3500 Crew Cab Dually Long Bed. I checked with TorkLift and the correct kit for the front is part #TLC2219 and the correct kit for the rear is part…

view full answer...

Answer 2

If your 2015 GMC Sierra 2500 has no steps or running boards and a factory hitch then I have the following options based on bed length and cab: 6-1/2' Bed - TorkLift Custom Frame-Mounted Camper Tie-Downs - Front #TLC2220 8' Bed (Crew Cab) -…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 10

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 11

There is not a plug and play adapter for your Lance connector that we are aware of. Typically this is installed by the Lance dealer. A junction box/7-way plug kit like #HS381-9000 is an option you have to convert the camper to match the 7-way RV…

view full answer...

Answer 12

The current Torklift tie down part #TLD3101 that you have installed on your 1997 Dodge Ram 3500 only fits if you have the factory hitch. If you go with the SuperHitch part #TLD1100 you would need to change your rear tie down to the part #TLR3503.

view full answer...

Do The Torklift Camper Tiedowns Come With Both The Front And Rear Set For The 2017 GMC Sierra 3500

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching