Recommended Replacement Electric Tongue Jack for Geo Pro Trailer

Question

Question:

I have a 2018 geo pro. The trailer is equipped with a jack it power tounge lift with an attached bike rack. The power lift now has a bad up down switch. Should I replace the switch or the whole jack. It may still be under warranty but the dealer is in another state.

asked by: Bill

0

Expert Reply:

The Lippert Electric Trailer Jack part # LC285318 would likely be a direct replacement for the existing tongue jack. That said, there is a newer upgraded model in the Lippert Power Stance Electric Trailer Jack part # LC69VR so this is what I recommend for a full replacement. They both should work with the Jack-It.

If you can provide me with the exact model number of the jack I can see if there is a replacement rocker switch assuming that's indeed the issue. The Lippert jacks all come with a one year warranty.

expert reply by: Conner L

0

Answer 1

It will indeed work; I just checked with Lippert for you and was able to verify the correct toggle switch for your Lippert Power Stance Electric Trailer Jack #LC69VR (which is the 813748), is the following: - Replacement Extend/Retract Switch for…

view full answer...

Answer 2

The Ultra-Fab Electric A-Frame Jack w/ 7-Way Plug - 18" Lift - 3,500 lbs #UF38-944037 most likely has a wiring issue since it will lift but not lower. The motor will be polarity sensitive, so it is likely the switch has failed. I recommend…

view full answer...

Answer 3

The Jack-It 2 Bike Rack for A-Frame Trailers #LC429756 we carry only comes with the angled stinger, but you can pick up the straight stinger separately as part #LC67HD on our site. This then allows you to have the bikes offset or directly above your…

view full answer...

Answer 4

Yes. I believe it is the Thule HideAway Awning like #TH490008 being used. However you will want the direct mount version which is part number #TH490018 to add it aftermarket to a trailer. This will include the correct mounting brackets you will…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey HPA, I would go with the Air Lift kit part #AL64VJ that fits your 2019 Toyota RAV4 based on what you described and your needs. This gives you adjustable support that you can tailor as needed so that you get the exact amount of support you need…

view full answer...

Answer 9

I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…

view full answer...

Answer 10

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...