Will the Yakima BackSwing Fit on a 2020 Toyota Highlander XLE

Question

Question:

Will this fit on a 2020 Toyota Highlander XLE? Thank you!

asked by: Susanne

0

Expert Reply:

As long as your 2020 Toyota Highlander XLE has a 2" hitch receiver then the Yakima BackSwing # Y02483 will work just fine and allow you to install a bike rack that swings away from the back of vehicle. It looks like all of the available hitches for the 2020 Highlander are 2" receivers so this shouldn't be an issue.

expert reply by: Erik B

0

Answer 1

I see the movement you are referring to in the attached video. The Yakima BackSwing Swing Away Hitch Extender #Y02483 will likely add some form of bounce or movement compared to not using it at all since it adds a few components and moving parts to…

view full answer...

Answer 2

I got you girl! From all the different bike racks we have down here in etrailer, there are a select few that I actually enjoy lifting and installing by myself. As another strong but small independent woman, I understand the struggle. Attached at…

view full answer...

Answer 3

The Yakima BackSwing #Y02483 will work with any bike rack that has a 2 inch shank. Unfortunately, it cannot be used with reducers, extenders, or adapters. So if your Kuat has a 2 inch shank, you are good to go.

view full answer...

Answer 4

The Thule Helium Bike Rack for 2 bikes will work perfectly with your 27-1/2" wheels. I've attached a review video for you to take a look at as well.

view full answer...

Answer 5

I measured the bolt that is included in the Yakima Replacement parts kit #Y8780022 and found it has the following dimensions: Overall Length 4-5/8 Hex Head Size 13/16 Thread diameter 1/2 Length of Thread 2-1/2 I prepared a photo with these…

view full answer...

Answer 6

I believe you are asking for the replacement hitch bolt for your Yakima BackSwing Swing Away Hitch Extender #Y02483, which is something that we do carry: - Replacement Hitch Bolt, Nut and Clip #Y8780022 I did verify for you with Yakima that this is…

view full answer...

Answer 7

If the nut is stripped inside the anti-rattle insert that is included in the Replacement Hitch Bolt, Nut and Clip for BigHorn 4 Bike Carrier #Y8780022 then you will need to purchase a new kit. Anytime there is a replacement option for equipment…

view full answer...

Answer 8

I recommend using the Yakima HoldUp EVO #Y02443 with the Yakima BackSwing Swing Away Hitch Extender #Y02483 for your application. From what I've looked at in the past there aren't many bike racks that will sit low enough for that…

view full answer...

Answer 9

Yes you can, the Yakima Backswing pivoting hitch adapter part #Y02483 that you referenced actually comes with a locking hitch pin too so you wouldn't need to get one separately.

view full answer...

Answer 10

I would be happy to help! On the Yakima BackSwing Swing Away Hitch Extender for Bike Racks - 2" Hitches #Y02483 from the top of the shank that goes inside of your trailer hitch receiver to the top of the extender measures 4-3/4" as…

view full answer...

Answer 11

To carry 4 bikes on your 1999 Chevy Suburban that has barn doors, I have two recommendations that will allow you access to your cargo area while the bikes are loaded. The first rack I recommend is the Thule Apex #TH9027XT which actually swings away…

view full answer...

Answer 12

The hitch from your Toyota Sienna will not fit your 2018 Toyota RAV4. I recommend using the etrailer Trailer Hitch Receiver #e98864 which is a confirmed fit for that vehicle. That will allow you to use your current 4 Bike Thule Rack on your new…

view full answer...

Will the Yakima BackSwing Fit on a 2020 Toyota Highlander XLE

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching