Does Valterra EZ Valve Double Electric Waste Valves Need to Install Near Both Pipes

Question

Question:

Installing E85-8. I have a 2014 Rockwood Windjammer 3025W. I would like to install an electric double valve for black and gray water. Do I connect directly to the down pipe pictured or do I go further up inside to connect?

asked by: Jesse C

0

Expert Reply:

Thanks for the photos, and you will need to install the Valterra EZ Valve Double Electric Waste Valves - Rotating - (3) 3" Hubs # E85-8 further up.

The valves need to connect to your gray and black water tank and then to the down pipe; to secure the EZ Valve to your pipes you will also need the Valterra ABS Solvent Cement # A05-0303.

I have added a link below to the installation instructions for you to check out as well of the Valterra EZ Valve Double Electric Waste Valves # E85-8.

expert reply by: Kyle S

0

click to enlarge

Answer 1

The difference between the Valterra EZ Valve Electric Waste Valves #E85-8 and #E84-8 is the design of the center output tube. On #E85-8 it's a straight, regular hub. On #E84-8 the center tube has bayonet fittings. Based on your pictures you would…

view full answer...

Answer 2

Since sewage connectors do need a proper seal (typically by using solvent #A05-0303) I do recommend changing out some of your sewage pipes as they are looking a bit rough. It does look like you have a 3" round pipe from your photo so if you were…

view full answer...

Answer 3

We do offer Global Link lock parts like #295-000077 which is a cam lock cylinder that can be ordered in multiple that are keyed alike. This service can be selected on the item's page using the drop-down menu tool's KEYED ALIKE option. There…

view full answer...

Answer 4

Since you have a 1-1/2 inch gray water tank valve what you'd want is the part #T1001VP for that size. We don't have an electric version of this though.

view full answer...

Answer 5

The difference between a hub connection and a spigot connection is that the hub is the female end and has a lip on the inside that stops the spigot (or male) end where it needs to be. I have attached some pictures to assist. With this knowledge it is…

view full answer...

Answer 6

The abs cement isn't going to come loose and will require you to cut the pipe a bit further back and using a coupling #D50-2935 and more straight pipe to get back to where it originally sat for the valve. That being said, you can also just unbolt…

view full answer...

Answer 7

You can try removing the screw, but I don't believe that's the issue. It sounds like your cable might be broken or the actual valve has just locked up or "frozen". There is currently not a replacement cable available for the LaSalle…

view full answer...

Answer 8

Normally the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets #MO34VR install on outsides of trailer frame. I attached an install video for this for you to check out as well.

view full answer...

Answer 9

The Mount-n-Lock SafetyStruts Universal Kit #MO34VR includes the Standoff Spacers #MO54VR along with drill bits and the components found in the Standard Kit #MO22FR. The standoff spacers allow for mounting on I-beams shorter than 6".

view full answer...

Does Valterra EZ Valve Double Electric Waste Valves Need to Install Near Both Pipes

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching