Warranty of Lippert LC364262 Replacement Motor with Brake for In-Wall RV Slide-Out

Question

Question:

What is the warranty on this part?

asked by: Eric V

0

Expert Reply:

The US-made Lippert # LC364262 Replacement Motor with Brake for In-Wall RV Slide-Out carries a 1 year warranty.

expert reply by: Mike L

0

Answer 1

Since the location of your hitch pin hole and the safety chain tabs don't allow you to use a skid wheel like part #UF48-979020 or #RM-050, the only other option that may work is if you welded a skid wheel like part #UF48-979021 onto the bottom of…

view full answer...

Answer 2

Yes, the Roadmaster Rollaway Skid Wheel part #RM-050 will fit the Curt hitch you have installed part #13358. To determine where the roller will be relative to the hitch height you'd need to measure 3-1/4 inches down from the hitch pin hole.…

view full answer...

Answer 3

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

I really wish we had replacement parts still for the Atwood couplers but since they've been out of business for so long we don't have any way to get the parts you are wanting.

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

The trailer hitches that fit a 2023 Ford Escape will not fit the Plug-In Hybrid version so we'll need to look into some alternative options so you can carry your extra cargo. If you just need to carry some bikes then I recommend getting the…

view full answer...

Answer 8

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 9

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 10

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 11

Depending on how your Topkick is equipped, you may need up to 3 items to install a brake controller. If the vehicle does not already have a trailer wiring harness you will first need to install a 4-way wiring harness. Since you seem to have a…

view full answer...

Answer 12

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Warranty of Lippert LC364262 Replacement Motor with Brake for In-Wall RV Slide-Out

Product Page this Question was Asked From

Continue Researching