Can Go Power Retreat Solar Charging System Controller # 34272635 Work with 12 Volt Battery Bank

Question

Question:

2018 Jayco 22J Class C I want to add solar to RV . It has 3 house batteries . Can I use the # 34272635 for the 12 volt system? Batteries are wired In series Thanks /

asked by: Steve

0

Expert Reply:

Yes the Go Power Retreat Solar Charging System with Digital Solar Controller # 34272635 is designed for use with 12 volt battery banks like what you have so it would fit and work great.

expert reply by: Jameson C

0

Answer 1

To add more solar panels to your trailer you'll need to ensure that the solar charge controller can handle the load before purchasing additional panels and you'll want to purchase the same wattage. For example, if you add in a 100 watt panel…

view full answer...

Answer 2

Your Flagstaff E Pro 12SRK will have the Go Power Retreat Solar Charging System with Digital Solar Controller #34272635 installed at the factory. You can add up to an additional 4 Solar Panels #34272634 with the your 30 amp charge controller. Each…

view full answer...

Answer 3

Go Power Retreat Solar Charging Kit w/ Digital Controller - 100 Watts - 5.43 Amp #34272635 is expandable to multiple panels using the Go Power Retreat-E Expansion Kit - 100 Watts - 5.43 Amp #34272634. If you want more power, you may want to consider…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...