Baby Moon Cover that Fits Dexstar Conventional Wheel on Shasta 2015

Question

Question:

Will these baby moon fit?

asked by: Rex E

0

Expert Reply:

Yes the Baby Moon Cover part # AM90086 that you referenced is a fit for the Dexstar conventional style wheel you send in a picture of. I was able to verify this by looking at the sticker in your picture.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The measurement that you will want to take is the outer diameter of the inner ring and the outer diameter of the inner ring with one of the tabs (see photo). You will also want to count the bolt holes on the wheel and know the wheel diameter. The…

view full answer...

Answer 2

The Americana Baby Moon Trailer Wheel Center Cap, part #AM90086, is a shiny, chrome-plated steel finish. When photos are taken in our studio, they use a dulling spray so that the shape of the wheel cap is shown without the reflection that would…

view full answer...

Answer 3

Appreciate the purchase and we do have baby moon hubcaps that fit the Dexstar Conventional Steel Wheel #AM20334. The correct fit for these wheels are the Americana Baby Moon Trailer Wheel Center Cap #AM90086.

view full answer...

Answer 4

We do offer trailer Baby Moon hubcaps #AM90086 and #AM981306 which fit different sizes of conventional steel trailer wheels like #AM20504. We also have wheel center caps like #319EZ that fit specific styles and sizes of aftermarket wheels. All of…

view full answer...

Answer 5

The depth of the Americana Baby Moon Trailer Wheel Center Cap part #AM90086 is 2-3/4". The Americana Pointed Top Baby Moon Trailer Wheel Center Cap part #AM981306 has slightly more depth at 3" so they should both clear most grease…

view full answer...

Answer 6

There are a few ways to determine what bolt pattern you have on your '60s Serro Scotty trailer wheels with the most common being that you measure from the center of one bolt hole to the center of one directly across for an even number of bolt…

view full answer...

Answer 7

Do you see the three raised bumps on the center circle section of your wheel? That's where a baby moon like the part #AM90086 fits over. You need to measure that diameter. If it's right at 9-1/4 inch this cover is what you'd need.

view full answer...

Answer 8

For the Dexstar Trailer Wheel part #AM20232 that you referenced the only type of cap we offer that will fit this wheel is a center cap like the #319EZ which fits through the pilot (center) hole of the wheel. The baby moon caps only fit the…

view full answer...

Answer 9

We have one baby moon wheel cover for a 15 inch wheel with 6 lugs. For that we have the part #AM981306. It measures 10-9/16 inches overall and has an inside diameter of 10-1/4 inches. I attached a review video for this cap for you to check out as…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Baby Moon Cover that Fits Dexstar Conventional Wheel on Shasta 2015

Product Page this Question was Asked From

Continue Researching