Can Main Harness of Aero Pro LED Trailer Light Kit be Extended Longer

Question

Question:

Do you have 28 to 30 ft harness lengths for over 80 inch wide trailers or maybe an extension harness?

asked by: Thomas G

0

Expert Reply:

The 4-way wiring harness that comes with the # TL16RK is 25 feet in length and while we don't have a version that comes with a longer harness you could pretty easily extend this 4 more feet with the # HM47114.

expert reply by: Jameson C

0

Answer 1

Based on what you described it sounds like you are looking for the part #A45CB which is a 2 prong connector designed for similar trailer clearance lights.

view full answer...

Answer 2

Absolutely, you can check just behind the rear tire on the driver's side of your 2019 Kia Sorento, on the outside of the frame rail. The factory connector, if present, will look like the one in the attached photo (B). Note that you will need to…

view full answer...

Answer 3

For your 2018 Hyundai Santa Fe with the factory tow package I recommend the Curt T-Connector Vehicle Wiring Harness #C56332. This particular harness features a higher amp rating than the other options available for your vehicle and Tekonsha is well…

view full answer...

Answer 4

To install a side marker light like the Optronics #AL82AB on your 2014 Malibu you will need to ground the white wire and then connect the black wire to your running light circuit. This then installs on the mounting bracket #A91BOB which you will need…

view full answer...

Answer 5

The LED Trailer Light Kit for Trailers Over 80" Wide part #TL16RK comes with a trailer wiring harness that has both the vehicle side plug (three covered, one exposed pin) and the trailer side plug (three exposed, one covered). Therefore, it has…

view full answer...

Answer 6

First, if you are switching to LED lights on the trailer, make sure to replace all of the incandescents with LEDs. Mixing the two styles can result in some of the lights not working and/or malfunctions. Clearance lights, LED or otherwise, that have 2…

view full answer...

Answer 7

Though we do recommend having a resistor on each LED light, we do have other options as well. Since you mentioned having a 7 Way connector, you could use a lamp out sensor adapter like the #20142 if the trailer is wired with a 7 Way plug or a #C35FR…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...