Mounting Bracket for LED Backup Light

Question

Question:

Please confirm the following are all compatible: BUL111CB - backup light a70gb - light grommet A45CB - PL-3 plug 337LB1 - mounting bracket I choose this bracket because it did not have screw mounting holes pre-drilled. Thanks

asked by: Greg B

0

Expert Reply:

I can confirm for you that each of the parts you mentioned will indeed work together:

- GloLight LED Backup Light # BUL111CB

- PVC Grommet # a70gb

- 2-Wire Pigtail # A45CB

- Mounting Bracket # 337LB1

I have added some links to video reviews for you to check out as well.

expert reply by: Kyle S

0

Answer 1

There are no white, oval LED tail lights we carry which have a curved face. We do carry the 22 diode GloLight LED Backup Light #BUL111CB which is submersible but you would need to make your own mounting spot as it is a recess mount that also requires…

view full answer...

Answer 2

The diodes are actually the only things that light up on the GloLight LED Backup Light #BUL111CB. So when they light up the ring technically lights up (see attached photo). We do have the surface mount version as part #BUL111CFPG!

view full answer...

Answer 3

To add additional backup lights like GloLight LED Backup Light for Truck or Trailer - Submersible - 22 Diodes - Oval - Clear Lens - Qty 1 #BUL111CB, you will want to splice into the reverse function wire on your trailer. For a 7-way, this is…

view full answer...

Answer 4

According to Buyers Products, their #3371492135 Low Profile LED floodlight is not submersible. If the lamp was submerged it would be damaged. We do however have an alternative. I'd recommend using part #BUL111CB, along with the #A70GB grommet and…

view full answer...

Answer 5

The #STL22CCRB lamp you referred to is typically mounted in a grommet, like part #A70GB, which in turn is mounted in a bracket like part #337LB1SS. If you were planning on cutting a hole to mount the lamp and grommet, the hole will need to measure…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 10

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Mounting Bracket for LED Backup Light

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching