Replacement Control Module for 2019 Jayco North Point RV Recliner

Question

Question:

I have a 2019 Jayco North point and I have the box of the right reclining chair don’t know the manufacturer number but this is on the box recliner has heat massage lights and reclines but it won’t back down so I’m sure it’s the box even though everything else works on it but there was a clicking coming from box this is the SN number on the box I want to make sure I get the right part

asked by: Rudina

0

Expert Reply:

Thanks for the picture of your current module. Based on that the correct replacement module is the part # LC36FR that you referenced.

expert reply by: Jameson C

0

click to enlarge

Answer 1

We have the control box you are looking for with the part #LC36FR.

view full answer...

Answer 2

The correct replacement control box for a Thomas Payne Seismic Recliner is the Replacement Power Control Box part #LC36FR. It does not come without the pigtails but if you did not want to use these you could remove them from the unit and use the…

view full answer...

Answer 3

Thanks for the pictures of the control box you are in need of for your RV recliner. Based on that the correct replacement is the Lippert #LC36FR that you referenced.

view full answer...

Answer 4

From the issues you are describing, it sounds like you are most likely having an issue with your control box. From what I could find using the pictures you provided, I believe you most likely have the Thomas Payne Seismic Recliner or Sofa which would…

view full answer...

Answer 5

Yes, the Replacement Power Control Box for Thomas Payne Seismic Recliners and Sofas #LC36FR does come with all the wires shown in the photos, including the connector. Keep in mind this is a replacement specifically for the Seismic line of Thomas…

view full answer...

Answer 6

For your Thomas Payne dual reclining loveseat, there could be a number of reasons why your recliner will not recline any longer. Lippert, the manufacturer of these recliners, has recommended you first unplug the unit from power, and let it sit for…

view full answer...

Answer 7

The easiest way to rule out a faulty cup holder on the Thomas Payne Seismic Recliner is to simply switch the cup holder from one side to the other. If the issue doesn't carryover you know that's not the problem and it's likely the control…

view full answer...

Answer 8

What seat do you have? It sounds like it's a bad cupholder based on what you mentioned and if you have a Thomas Payne Momentum setup the part #195-387597 that you referenced would be correct for it.

view full answer...

Answer 9

According to Lippert, the manufacturer, if the light went out on the cupholder, that generally means the connection is poor at the plug, so you'll want to check that. To do so, remove the rubber coaster from the bottom of the cupholder, and using…

view full answer...

Answer 10

To get the cup holder removed, you will need to locate a notch inside the cup holder. You should be able to feel with your hand, but can be a little tedious. Once you find it, you will need to use a flathead screwdriver to pop it up as this will…

view full answer...

Answer 11

We have just the controller of the #LC47VR with the part #LC36FR which it sounds like is just what you are looking for.

view full answer...

Answer 12

When looking into why your Thomas Payne Power Recliner won't recline it sounds like the control boxes have gone bad. The Replacement Control Box For Thomas Payne Momentum Recliners and Sofas #195-387596 will get your recliner to recline again.…

view full answer...

Replacement Control Module for 2019 Jayco North Point RV Recliner

Product Page this Question was Asked From

Continue Researching