Troubleshooting Thomas Payne RV Love Seat with Cupholder That Light Flickers

Question

Question:

see attached picture

asked by: Susan

0

Expert Reply:

What seat do you have? It sounds like it's a bad cupholder based on what you mentioned and if you have a Thomas Payne Momentum setup the part # 195-387597 that you referenced would be correct for it.

expert reply by: Jameson C

0

Thomas Payne Cupholder
(click to enlarge)

Susan

2/3/2022

see attached picture

Reply

Jameson C.

2/3/2022

Thanks for the picture, based on that you definitely need the part # LC38FR.

Reply

Answer 1

According to Lippert, the manufacturer, if the light went out on the cupholder, that generally means the connection is poor at the plug, so you'll want to check that. To do so, remove the rubber coaster from the bottom of the cupholder, and using…

view full answer...

Answer 2

I spoke with my contact at Lippert who said that there is a notch in the side of the cup holder that you should be able to feel with your hand. I attached a picture of where it is as well. Once you find it you will need to use a flathead screwdriver…

view full answer...

Answer 3

First you will want to unplug the main power unit going into the back of the Thomas Payne recliner. Next you will want to relocate the connector and check to see if any of the prongs may be bent or damaged in the connector. Be sure to check both…

view full answer...

Answer 4

Yes, the Replacement Power Control Box for Thomas Payne Seismic Recliners and Sofas #LC36FR does come with all the wires shown in the photos, including the connector. Keep in mind this is a replacement specifically for the Seismic line of Thomas…

view full answer...

Answer 5

Since you mentioned you've already replaced your cupholder #195-387597, and your power cord #195-387595, I suggest you try to reset the chair if not preformed already. You'll want to unplug the unit from power, and let it set for about 10…

view full answer...

Answer 6

We have the control box you are looking for with the part #LC36FR.

view full answer...

Answer 7

To get the cup holder removed, you will need to locate a notch inside the cup holder. You should be able to feel with your hand, but can be a little tedious. Once you find it, you will need to use a flathead screwdriver to pop it up as this will…

view full answer...

Answer 8

The Thomas Payne Seismic Left Arm Power RV Recliner w/ Heat, Massage, LED Lights #195-000099,which is no longer available. does in fact have heating and cooling options. Start by checking the wiring of the heating pad for continuity when the heating…

view full answer...

Answer 9

I spoke with my contact at Lippert who said that there is a notch in the side of the cup holder that you should be able to feel with your hand. Once you find it you will need to use a flathead screwdriver or a butter knife to pop it up. This will…

view full answer...

Answer 10

Since your Thomas Payne Recliner has no power for any function, I recommend first plugging something into the outlet to make sure that isn't the issue. Next, I recommend checking the Cup Holder #195-387597 and it's wiring connection because…

view full answer...

Answer 11

Thanks for the picture of your current module. Based on that the correct replacement module is the part #LC36FR that you referenced.

view full answer...

Answer 12

It sounds like the control box is faulty on your Thomas Payne recliner, however, you could also try unplugging the chair for 10+ minutes to let the chair reset and also check for any wires that could have been pinched and damaged. If it is still not…

view full answer...

Troubleshooting Thomas Payne RV Love Seat with Cupholder That Light Flickers

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching