Correct Replacement Power Control Box for Thomas Payne Seismic Recliner

Question

Question:

The massage function starts when the recliner is powered up and cannot be turned off. The problem appears to be In the control box. Can I replace just the control box and use the existing wire harness? The problem started one night about 6 months after I purchased the seats.

asked by: John J

0

Expert Reply:

The correct replacement control box for a Thomas Payne Seismic Recliner is the Replacement Power Control Box part # LC36FR. It does not come without the pigtails but if you did not want to use these you could remove them from the unit and use the existing so you don't have to run any additional wires.

expert reply by: Conner L

0

Answer 1

Thanks for the picture of your current module. Based on that the correct replacement module is the part #LC36FR that you referenced.

view full answer...

Answer 2

Yes, the Replacement Power Control Box for Thomas Payne Seismic Recliners and Sofas #LC36FR does come with all the wires shown in the photos, including the connector. Keep in mind this is a replacement specifically for the Seismic line of Thomas…

view full answer...

Answer 3

From the issues you are describing, it sounds like you are most likely having an issue with your control box. From what I could find using the pictures you provided, I believe you most likely have the Thomas Payne Seismic Recliner or Sofa which would…

view full answer...

Answer 4

We have just the controller of the #LC47VR with the part #LC36FR which it sounds like is just what you are looking for.

view full answer...

Answer 5

The Replacement Power Control Box for Thomas Payne Seismic Recliners and Sofas #LC36FR is the correct part for your Thomas Payne Seismic Series Recliner. If you have not already, preform a hard reset on your chair before continuing. To do this unplug…

view full answer...

Answer 6

We have the control box you are looking for with the part #LC36FR.

view full answer...

Answer 7

Yep, you got it right. The correct replacement control box for your Seismic is indeed the one you mentioned: - Replacement Power Control Box for Thomas Payne Seismic Recliners and Sofas #LC36FR

view full answer...

Answer 8

For your Thomas Payne dual reclining loveseat, there could be a number of reasons why your recliner will not recline any longer. Lippert, the manufacturer of these recliners, has recommended you first unplug the unit from power, and let it sit for…

view full answer...

Answer 9

What seat do you have? It sounds like it's a bad cupholder based on what you mentioned and if you have a Thomas Payne Momentum setup the part #195-387597 that you referenced would be correct for it.

view full answer...

Answer 10

If you need to remove one of the cup holder assemblies on your Thomas Payne Momentum Recliner you can do so by first locating the notch on the side of the cup holder that you should be able to feel with your hand. Then it's just a matter of using…

view full answer...

Answer 11

There are no fuses on the recliner for the massager. If everything is working besides the massage function you could have a damaged wire leading to the massager. A faulty massager or a bad Control Box #LC36FR. I recommend testing for power along the…

view full answer...

Answer 12

What you can first try, if you have not already, is unplugging and plugging back in the sofa. You'll want to make sure to wait at least 10 minutes before restoring power. It also wouldn't hurt to check the wiring as well, and make sure…

view full answer...

Correct Replacement Power Control Box for Thomas Payne Seismic Recliner

Product Page this Question was Asked From

Continue Researching