Install Video for 4-Pole Wiring for 2001 Ford F-150

Question

Question:

I have a 2001 Ford F-150 XL regular cab. Will this wiring fit? Do you have an installation video?

asked by: Calvin

1

Helpful Expert Reply:

Part # C55344 works for your 2001 Ford F-150. We do not currently have an install video for you to reference, but this is a straight forward install. You remove the driver side tail light, plug in the new harness, drop the rest of the wires down, run the green wiring to the passenger side tail light and make the connections there. I attached the instructions to help walk you through the process of getting the wiring installed.

expert reply by: Clayton O

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

We had a customer who was able to replace his Dexter 8-155 hubs with the #8-201-5UC3-EZ that you referenced so they should work well for you. You can verify that this hub will work for you by pulling your current hub and making sure they have inner…

view full answer...

Answer 4

Hello Curtis. You can absolutely use an RV mount tow bar with your 2006 Ford E350 Van. For example, the Blue Ox Avail Non-Binding Tow Bar #BX7420 is compatible with any 2" hitch receiver. This could be on a motorhome, van or pickup truck. As…

view full answer...

Answer 5

The mounting holes the Curt Trailer Hitch Receiver #14053 measure 38-1/4" and 38-3/4" width-wise and then from the center of the of the forwardmost to the rearmost is 13-1/4". Attached is a dimensional photo for you to reference. This…

view full answer...

Answer 6

To equip your Escort for towing, you will need 5 parts. A hitch, ball mount, pin and clip or hitch lock, trailer ball, and a wiring harness to supply lighting for your trailer. I recommend the Curt Class I Receiver Hitch, part #C11105, with ball…

view full answer...

Answer 7

The only trailer hitch available for the 1999 Ford Escort ZX2 is a Class I hitch #C11105. The recommended ball mount is #C45520. For a 1-7/8 inch ball use #19257 and for a 2 inch use #19258. For trailer wiring use #118344 to add a 4-Way flat…

view full answer...

Answer 8

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 9

When it comes to installing The Redarc Tow-Pro Liberty #RED52VR if there is no trailer connected, the active calibration may occur as normal without any indication from the LED., provided your brake light trigger point is active when there is no…

view full answer...

Answer 10

We do have a fit for a step bumper for your 2012 Ford van, though it is a different part number than you mentioned. What you will need is the Westin Fey Diamondstep Rear Bumper #20107. A separate mounting kit isn't needed for this bumper because…

view full answer...