Lippert Components Anti Billow Arm Inner Diameter

Question

Question:

RV slide awning, what is the I D of the arm?

asked by: Shawn P

0

Expert Reply:

The Lippert Components Anti-Billowing Kit for Solera Slide Topper Awnings - Black # LC78FR is designed to fit right over the slide awning roller as pictured. The inside diameter of the arm is 2.545 inches according to my tech contact at Lippert.

expert reply by: Jason S

0

click to enlarge

Answer 1

Please note the attached instructions. The Lippert Anti-Billowing Kit for Solera Slide Topper Awnings, #LC78FR should be installed on the end of the awning that is closest to the front of the unit. 1. Make sure awning is fully retracted. 2. Place the…

view full answer...

Answer 2

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 3

We do have slide toppers for two of your slides, the ones that measure 80 inches and 96 inches from flange to flange; there is not one that is short enough for the 55 inch measurement, however. For the toppers, you can choose from either White or…

view full answer...

Answer 4

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...

Answer 5

There's no reason you couldn't install the Sportrack roof rack part #SR1020 on your 2016 Aliner Scout so that when it's folded down you could then use a J-style kayak carrier to carry kayaks like the Yakima JayLow part #Y04073. This is a…

view full answer...

Answer 6

In general, the higher the gear ratio such as 4.10, the more improvements you'll see while towing. I really can't speak specifically about any one particular vehicle but so long as you are towing within the confines of the vehicle, the gear…

view full answer...

Answer 7

Thank you for all of the information and pictures! It looks like you should at least have some wiring already run on your 2019 Chevy Express Van 3500 so I'm just as confused as to why you don't have a round plug with a cap inside the…

view full answer...

Answer 8

I was not able to locate anything on that part number, however since you have a 2016 model year trailer there is a good chance the awning was made after 2015 in which you'd need the Replacement Motor for Solera Power RV Awnings Manufactured after…

view full answer...

Answer 9

I spoke with the manufacturer, Lippert, and was told that the Lippert Anti-Billowing Kit for Solera Slide Topper Awnings #LC78FR is only going to be compatible with Solera slide out awnings so if you're awning is Solera branded you'll be fine…

view full answer...