Replacement Awning Motor Options for a Lippert Solera Awning W/ A Venture Motor

Question

Question:

I have 2016 Keystone Bullet 243BHS! They awning motor died! I need to know replacement for Lippert Solera! The old motor reads: Venture MFG co SN 8855631

asked by: Joan

0

Expert Reply:

I was not able to locate anything on that part number, however since you have a 2016 model year trailer there is a good chance the awning was made after 2015 in which you'd need the Replacement Motor for Solera Power RV Awnings Manufactured after 2015 # LC373566.

If it turns out the motor was made prior to 2015, then you'd want the Replacement Motor for Solera Power RV Awnings Manufactured before 2015 # LC266149 instead.

expert reply by: Bryce D

0

Answer 1

The Replacement Motor for Lippert Solera Power Awnings #LC373566 works with awnings with a range of sizes including up to 20 ft. so size is not an issue. This motor will work for you if you are replacing the motor on a Solera power awning…

view full answer...

Answer 2

Are you sure that's the part number? I wasn't able to find any reference to that. Can you see a brand on the motor?

view full answer...

Answer 3

I can see from your pictures that you have the Lippert Edge Awning. You can replace just the motor on that awning. The correct replacement motor is the Replacement Motor for Lippert Solera Power Awnings #LC373566. You will need to partially extend…

view full answer...

Answer 4

We do have something that will help. Honestly, your best option for noise reduction is to roll the awning up. That said, since your awning has the Solera Smart Arms you can add the Solera Smart Arm Wind Sensor Kit #LC715123. The Solera Smart Arm Wind…

view full answer...

Answer 5

It is important to differentiate between, (1.) A typical RV awning that is powered by the 12 volt battery system built into your RV, or (2.) An independent awning that is NOT connected to your RV's 12 volt battery system, but rather has it's…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

The correct replacement gear motor that replaces the Power Gear 1510000006 on your 2006 Fleetwood Fista is the Replacement PowerGear RV Above Floor Slide-Out Motor #LC368417. The Replacement Gear Motor #LC368193 you were looking at will not work…

view full answer...

Answer 12

The Camco RV and Marine Premium Water Filter, part #CAM40631, uses a standard garden hose connection of 1/2" inner diameter and 1" fitting. If the 1/2" input and output connection types you have are male then you won't need any…

view full answer...