High Capacity Suspension Enhancement for a 2012 Dodge Ram 1500

Question

Question:

I am looking to beef up my 2012 ram 1500 rear suspension but am looking for a bit more support than helper air bags. I understand the load limits of my truck. That being said can this part number be installed on a 1500, or is the frame and axle physically different from 2500s

asked by: Garrick

0

Expert Reply:

The frame and suspension is different between the 1500 and 2500 series 2012 Dodge Ram so the parts are not interchangeable. But if you want the most capacity for a 1500, take a look at the Timbren springs # TDRTT1500. These guys are rated for 7,000 pounds and would be ideal for beefing up your suspension.

The Timbren springs will provide leveling support independently of each other, increase stability and ride quality, and reduce side to side body roll. I have included a link to an FAQ article on Timbren springs for you.

expert reply by: Michael H

0

Answer 1

In this case, I recommend using the SumoSprings Solo Custom Helper Springs - Rear Axle #SSR-307-47 because they'll do a bit better job of keeping the factory ride nice and comfortable; these springs provide 1500-lbs of load leveling capacity, so…

view full answer...

Answer 2

Yes, the Firestone Coil-to-Air-Spring Conversion Kit part #F2595 is going to help take the sag out of your 2012 Ram 1500 while hitched to your boat trailer. This system will actually replace the leaf springs on the truck with a set of air springs. I…

view full answer...

Answer 3

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

If you are considering Timbrens like the #TDR1500DQ and the SumoSprings like the #SSR-307-47 for your 2022 Ram 1500 4x4, I recommend the SumoSprings #SSR-307-47. The SumoSprings will offer the same quality as the Timbrens in terms of suspension…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 11

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...