Recommendation for Wiring a Camper to a 7-Way Wiring Connector
Question:
I have a 2006 Dodge Ram 3500 with a 7 pin plug at the bumper and 1 - 7 pin plug 8foot away at the front of the bed. I was contemplating tying the modulite in at the current splice point in the truck factory harness. The modulite will only need to control the turn signal and stop lights on the trailer and camper at the moment. Sensor wires would either have to be run aft to the rear tow vehicle lights or forward to the front signals. Does this seem feasible? Also, with only one stop wire in the modulite, how does it send stop signal to both left and right tail lights?
asked by: Dave H
Expert Reply:
What I would do in your situation is take a trailer side 7-way like the # H20046 and make an adapter out of it for your camper. So when the camper is in your truck you could just plug in the adapter to the 7-way located in the truck bed.
Without knowing what the wiring of your camper is like I attached a picture of a chart that shows the wiring code of the # H20046 so you would know how to wire it to your camper.
This will allow your trailer to still be able to use the 7-way at the rear.
Products Referenced in This Question
Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 6 - 10 Feet Long
- Plug and Lead
- 7 Round - Blade
- Hopkins
more information >
Product Page this Question was Asked From
ModuLite Ultra Protector Wiring Harness w/ Integrated Circuit and Overload Protection
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Redarc Tow-Pro Elite Brake Controller for Tekonsha Harness - 2 Modes - 1 to 3 Axles - Proportional
- Shop: Brake Controller
- Search Results: 118151
- Shop: Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Shop: ModuLite Installation Wiring Kit
- Shop: Performance Chip Tuners
- Search Results: carabiner
- Search Results: air gauge
- Search Results: fuse
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Trailer Hitch
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Video: Choosing the Right Brake Controller
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Search Results: 25580
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: 68149
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Video: Lippert Solera Slider Slide-Topper Review
- Shop: Fifth Wheel Hitch