Is Handle of 45" Long Side-Door Bar Lock Assembly # PLR3057-45 Centered on Bar

Question

Question:

IS THE HANDLE APPROXIMATELY 22-1/2 FROM EITHER END

asked by: EDDIE P

0

Expert Reply:

The handle of the 45" Long Side-Door Bar Lock Assembly # PLR3057-45 is centered on the bar so yes it's 22-1/2 inch on either side.

expert reply by: Jameson C

0

Answer 1

I'll give you a number of different dimensions for the hole spacing as I'm not entirely sure what you were specifically looking for on the 45" Long Side-Door Bar Lock Assembly #PLR3057-45. From the top mounting hole to the bottom…

view full answer...

Answer 2

I went and measured the mounting bracket of the 55" Lock Side-Door Bar Lock Assembly #3057-55 that you referenced and found that the actual bracket is 1-1/4 inches wide, but if you count the hinge portion that sits a bit above bracket the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Yes, the Dexter E-Z Flex Equalizer #K71-655-00 will indeed work with the standard 1-3/4" wide double eye leaf springs.

view full answer...

Answer 5

We do offer a few of the 7-3/4" long equalizers with 3 9/16" holes. Unfortunately, the standard equalizers in this size like the #TREQE1 are not greaseable. There is the Dexter E-Z Flex Equalizer #K71-655-00 which is a 7-3/4" long…

view full answer...

Answer 6

The closest thing we have to a 2" x 2" bumper is the Rubber Bumper for Enclosed Trailer Ramp Door #37210715 you looked at. This has a 2-1/2" diameter with a height of 1" and a 3/8" mounting hole.

view full answer...

Answer 7

If you already have a seal that you're replacing then you want to get a seal that's a similar size, otherwise if it's a brand new application then I recommend trying to find the depth of the gap and choosing a seal slightly taller since…

view full answer...

Answer 8

The only differences between the Demco Trailer Coupler #DM14976-52 and #DM88XR are the colors and the mounting bracket design. The part DM14976-52 is silver and has a straight, or no-drop, design with the bottom of the coupler being towards the top…

view full answer...

Answer 9

If you're getting that much bounce out of your trailer that would lead me to believe that maybe the MORryde IS suspension system is the actual issue. Typically if the suspension is too stiff you'll start to bounce. We see this issue a lot…

view full answer...

Answer 10

The Bulldog Powered Drive Trailer Jack #BD500199 grounds through the mounting hardware. I would recommend running a jumper wire from the mounting flange of the jack to the ground wire on your trailer wiring to see if you can get it to work that way.…

view full answer...

Answer 11

There is no reason why you could not turn the jack at a 90 degree angle to gain more clearance. Due to the configuration of the holes in the mounting flange, you might need to drill new holes in your trailer tongue to mount the jack in that…

view full answer...

Answer 12

I do have an option for you but the handles included with the Cam-Action Lockable Door Latch Kits like part #PLR658-SSP must be welded to the pole as there are no other options to attach them. If you can get away with a 55" long pipe then you…

view full answer...

Is Handle of 45" Long Side-Door Bar Lock Assembly # PLR3057-45 Centered on Bar

Product Page this Question was Asked From

Continue Researching