Replacement Switches for Lippert Electric Trailer Jack for A-Frame

Question

Question:

What switch fits the model # 1817941 3500 # power tongue jack for raising and lowering trailer?

asked by: Chuck C

0

Expert Reply:

The Lippert# LC285318 Electric Trailer Jack will use, the Replacement Extend / Retract Switch # LC226023 and Replacement On/Off Switch # LC226018. Both of these have been discontinued. You may be able to source something from an electronics supply house.

expert reply by: Jason S

0

click to enlarge

Answer 1

Yes, I confirmed with Lippert that the Replacement Top Cover for Lippert Components Electric Trailer Jack part #LC285160 will fit your Lippert 3,500 Lb Electric tongue Jack 1817941.

view full answer...

Answer 2

Only the RV manufacturer will be able to tell you if the bumper is strong enough for the weight of a carrier and generator, but we have the Ultra Fab bumper hitch part #UF35-946402 which is designed for 4 inch square bumpers and has a 350 lb tongue…

view full answer...

Answer 3

It could be a switch or ground issue pretty easily. Most powered A-frame trailer jacks ground through the mounting hardware so you'd want to make sure that the frame of the trailer is grounding properly to the ground harness of the trailer…

view full answer...

Answer 4

For your Lippert Power Jack you will need to use the replacement Top Cover #LC285160 as the switch is not available by itself. It will wire up exactly the same as the original, so what you can do before removing the original switch is take a photo of…

view full answer...

Answer 5

Yes for just the rubber plug for the top of the Lippert Jack part #LC285318 that you referenced you'd want the part #LC733924.

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 8

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 9

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Answer 10

The Replacement Amber Lens for MC32AB Trailer Lights #A32AB is a direct replacement for the SAE A P2 DOT 14 and would be what you'd need.

view full answer...

Answer 11

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 12

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...