Replacement Switch for my Lippert Components Powered Tongue Jack

Question

Question:

Replacement Extend / Retract Switch Assembly for Lippert Components Power Tongue Jack There are four terminals. Thanks.

asked by: Donald M

0

Expert Reply:

For your Lippert Power Jack you will need to use the replacement Top Cover # LC285160 as the switch is not available by itself.

It will wire up exactly the same as the original, so what you can do before removing the original switch is take a photo of the back of the original and how it is wired and use that as a simple reference to guide you on how to replicate the wiring.

expert reply by: Randy B

0

Answer 1

When it comes to checking your retract/extend functions not working it sounds like you may just need to swap some wiring on the back. I will attach picture of the wire swaps. It sounds funny but per the manfuacturer that does seem to help. If that…

view full answer...

Answer 2

Yes, I confirmed with Lippert that the Replacement Top Cover for Lippert Components Electric Trailer Jack part #LC285160 will fit your Lippert 3,500 Lb Electric tongue Jack 1817941.

view full answer...

Answer 3

The red power wire on the Electric A-Frame Tongue Jack, #LC285318, is the power wire and it will attach to the positive battery terminal on your trailer battery. First, remove the fuse in the in-line fuse holder on the red wire. Mount the jack to the…

view full answer...

Answer 4

Only the RV manufacturer will be able to tell you if the bumper is strong enough for the weight of a carrier and generator, but we have the Ultra Fab bumper hitch part #UF35-946402 which is designed for 4 inch square bumpers and has a 350 lb tongue…

view full answer...

Answer 5

It could be a switch or ground issue pretty easily. Most powered A-frame trailer jacks ground through the mounting hardware so you'd want to make sure that the frame of the trailer is grounding properly to the ground harness of the trailer…

view full answer...

Answer 6

The Lippert#LC285318 Electric Trailer Jack will use, the Replacement Extend / Retract Switch #LC226023 and Replacement On/Off Switch #LC226018. Both of these have been discontinued. You may be able to source something from an electronics supply…

view full answer...

Answer 7

To replace the extend/retract switch on your Lippert 181794 Electric Trailer Jack you'll simply need the Replacement Extend/Retract Switch for Lippert Electric Trailer Jack #LC49MD. If you're needing to replace the on/off or just both…

view full answer...

Answer 8

Since it won't retract you'll need to replace the switch with Replacement Extend/Retract Switch for Lippert Electric Trailer Jack #LC49MD.

view full answer...

Answer 9

I do have an option for you, however there is not a replacement motor available for your Lippert model 1817941 Electric A-Frame Trailer Jack. I recommend simply replacing the jack itself with the Lippert Electric Trailer Jack #LC285318, which is what…

view full answer...

Answer 10

Lippert does not offer a replacement inner jack tube for their jack 1817941. When a jack is damaged in this way (which is more common than you want to know) it really is best to replace the entire jack for safety reasons. The outer tube on your jack…

view full answer...

Answer 11

For the replacement top cover for your Lippert Electric Trailer Jack #LC285318 you will use the part #LC285160. This is the top plastic black cover that comes down over the switches. The protective lens for this jack is no longer available as a…

view full answer...

Answer 12

There are four screws that hold the lid part #LC285160 to the rest of the Lippert jack part #LC285318. If you check out the picture I attached you'll see the screw holes pointed out.

view full answer...

Replacement Switch for my Lippert Components Powered Tongue Jack

Product Page this Question was Asked From

Continue Researching