Recommended Rubber Caps for Elite Puck System

Question

Question:

Are there rubber caps that are designed to go inside of part #RP58458?

asked by: Mandy K

0

Expert Reply:

The Trim Ring # RP58458 fit around the Reese Elite Series 5th Wheel Rail Puck Adapters for Plastic Truck Bed Liner # RP30149 and the plastic caps # 58199 fit those.

expert reply by: Jason S

0

Answer 1

Reese Elite Made their puck system to match the the OEM version, you can use Replacement Puck Plug Covers for Elite and Signature Series Fifth Wheel Rails part #58199 to cover the holes. You will need Rubber Hole Cover for Reese Elite Series…

view full answer...

Answer 2

The Replacement Trim Rings for the Ford OEM prep package are part #RP58458. The Gooseneck hole does not have a trim ring but there is a gooseneck hole cover part #RP30136.

view full answer...

Answer 3

The replacement plug covers you need are the Replacement Puck Plug Covers #58199 which are a fit for the factory pucks you have in your 2014 Ford Super Duty.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 10

If you have the Ford 3" hitch then you can definitely add it but, yes it would change the weight capacity. The TorkLift Cannon Hitch Extension item #TLE1636 only has a 3,600 lbs towing capacity and a 360 lbs maximum tongue weight. If used with a…

view full answer...

Answer 11

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 12

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...