Coupler Pin Locks that Can be Keyed Alike

Question

Question:

I am wanting 6 or 8 adjustable trailer hitch coupler pin locks that all work from same key. Can you provide??? I never have correct key with me for my many trailers, and have to cut them off I don’t want to do this again. Thanks /

asked by: Michael S

0

Expert Reply:

We have coupler pin lock locks that can be keyed alike like the part # e98888 which has a span of 3-3/8 inches and # e98887 which has a 2-1/2 inch span. Or even # e98890 with a 7/8 inch span or # e98886 which has a 2 inch span.

On the product page you'll select keyed alike on the drop down menu and all of the locks will use same key.

expert reply by: Jameson C

0

Answer 1

I have another option for you but the MaxxTow Coupler Latch Lock for Surge Brake Actuators - 2-1/2" Span - 1/4" Diameter #MT46FR you were looking at cannot be ordered keyed alike. Instead I recommend the etrailer Surge Brake Coupler Lock -…

view full answer...

Answer 2

I have a different option for you, but there is no such adapter for raising and lowering your Bulldog 12,000lb trailer jack with an electric impact. The only non-manual option offered is the Bulldog Powered-Drive Kit for Single-Speed Jacks w/…

view full answer...

Answer 3

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 4

You are a little on the warm side for your transmission fluid. If you can keep it under 200 degrees you will have the max life out of it. That being said transmissions really start to go downhill at 260 degrees. The Derale cooler part #D13503 with…

view full answer...

Answer 5

Congrats on the new trailer! However you need to know the loaded tongue weight of your trailer, as the dry weight is not a useful figure. With your trailer fully loaded like you'll be towing it use either the scale method in the below help…

view full answer...

Answer 6

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

Hi Larry, So we have a couple bumpers that may work, though each is 96 inches long. They can be cut to length though, and the difference is their width, as one is 3" wide and the other 4" wide to fit different size bumpers: - Pre-Drilled…

view full answer...

Answer 9

The Replacement Shock Absorber Spring Kit #TK71-758-00 is the correct shock for your UFP Surge Brake Actuator. The picture you included does not specify if it is for a disc or drum brake set, so I have found both for you to choose from. Disc Brake…

view full answer...

Answer 10

The play you are feeling/hearing is most likely between the hitch ball and the latch of the coupler. If you look under the coupler you can see an adjustment bolt that uses an Allen wrench that will allow you to tighten the latch and get rid of the…

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

I reached out to my contact at Demco who was able to supply me with the attached dimensional photo of the Demco A-Frame Trailer Coupler #DM14793-95.

view full answer...

Coupler Pin Locks that Can be Keyed Alike

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching