Windshield Foam for 1999 Sea Ray DA

Question

Question:

Is the foam tape the right size for my windshield

asked by: Paul

1

Helpful Expert Reply:

Yes, the Taylor Made PVC Sealing Foam # 3691631 is the correct size for the windshield of your 1999 Sea Ray DA.

expert reply by: Jameson C

1

Answer 1

Since the foam you have now is 1-1/4 inch wide the correct replacement is the #3691631 you referenced. This is 5/8 inch thick which would be the correct thickness based on what yours is now after years of shrinking and compression.

view full answer...

Answer 2

The Taylor Made PVC Sealing Foam for Boat Windshields part #3691631 is a universal seal used to help cover up the exterior of a boat windshield. This can be used to cover worn and deteriorating seals, replace worn and deteriorating seals or to simply…

view full answer...

Answer 3

It is very likely to work, though there are no specific fits for the Taylor Made PVC Sealing Foam for Boat Windshields #3691631. In order to determine if it will work you will just want to measure the gap where it will fit, and compare that to the…

view full answer...

Answer 4

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 5

A drop axle certainly can make it tough to reach the star wheel adjuster on a drum brake. The adjuster spoon tool we offer #W80630 has a 90-degree bend that will often let you get access to the adjuster even on a drop axle. Essentially you will need…

view full answer...

Answer 6

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 7

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 8

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 9

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 10

We only have the products listed on our website. I just double-checked to see if there was anything matching your descripton. The 4 microwave/convection/OTR ovens are all well over your 24" wide location. One of the smallest is the Furrion…

view full answer...

Answer 11

On equalizer 013-105-04 in kit #K71-360-00 the eye center to eye center measurement is approximately 7-1/2 inches.

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Windshield Foam for 1999 Sea Ray DA

Product Page this Question was Asked From

Continue Researching