Seal for my Cattle Trailer that is 2 Inside and 2.895 Outside Diameter

Question

Question:

old square axles under a cattle trailer uses a 2id x 2.895od seals ,I am having trouble finding these seals

asked by: William S

0

Expert Reply:

If the Seal coming out was slightly misshapen this might be the one you are looking for Redline Grease Seal
Part # 1105-100-035. It has an outer diameter of 2.875" and an inner diameter of 2". Which is very close to your 2.895 outer diameter.

expert reply by: Randy B

0

Answer 1

Though we do have the replacement bearings, races, and seals available for your Hadco 3109 hub (which I have listed below), the combination used will not have an equivalent replacement hub available, unfortunately. Replacement Trailer Hub Bearing…

view full answer...

Answer 2

We have a large selection of 12 x 2 electric brake assemblies available, which I have linked for you to look through. I recommend looking at the etrailer.com Electric Trailer Brake Kit - Self-Adjusting #AKEBRK-7-SA. These 12 inch assemblies are…

view full answer...

Answer 3

The measurements from your spindle and hub line up with the HADCO seal #1105-100-035 that you were looking at. This will work as a replacement to your seal on your axle. Sounds like you were looking for a rubber coated one like the one that was…

view full answer...

Answer 4

After speaking to my contact at Redline, I have found the thickness of the Redline Grease Seal #1105-100-035 you referenced is .3 inches.

view full answer...

Answer 5

I may have an option for you but mobile home axles are considered a one-time use only product and are not designed to be used on a standard trailer. Therefore, there are no hub conversion kits for them that will allow you to use standard…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 12

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...