Replacement Foot Pad For Leveling System on 2020 Jayco Pinnacle 5th Wheel

Question

Question:

I have a 2020 Jayco Pinnicle 5thn wheel,, lost one of the foot pads.. Is this the part I will need to replace it Thanx

asked by: Johnny M

0

Expert Reply:

If your Jayco Pinnacle was equipped with the Lippert Hydraulic Ground Control Leveling System (which should be listed on the control panel), then yes the # LC324269 you'd looked at would be the correct replacement foot pad. If you're unsure of what system you have, I can likely get that information from Jayco if you reply to this email with the VIN of your 5th wheel. The 2020 Pinnacle could be equipped with a number of different leveling systems, and I want to ensure you get the correct part.

expert reply by: Mike L

0

Answer 1

All of the brake hoses, including the main brake line, are made of rubber on the 20 foot Kodiak Hydraulic Brake Line Kit - Tandem Axle #20TA-BLKIT. The hoses on the #20TA-BLKIT also have brass fittings with stainless steel flares.

view full answer...

Answer 2

Yes, both special trailer (ST) and light truck (LT) tires can be used on a 5th wheel trailer. They are actually the only two types of tires rated for this use. The reason for this is that tires on a trailer will be subjected to much harsher…

view full answer...

Answer 3

Yes it does, what you will need are 1/2"-20 self-tapping bolts in order to install the bracket you asked about: - Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 #LC349975

view full answer...

Answer 4

So it sounds like it is the "passenger's" side of the trailer which would be the right side. That would mean rear leg #LC344792 is the correct replacement for you.

view full answer...

Answer 5

The end plates on the MORryde X-Factor Crossmember for LRE, RE, or TRE Leaf Spring Suspension #MR99ZR measure 4" x 8". The mounting holes line up with the LRE, RE, and TRE brackets. See the dimensional drawing below.

view full answer...

Answer 6

It sounds like you are definitely on the right track here. The #MR79ZR is indeed the correct suspension upgrade kit for your 2007 Colorado 5th wheel with LRE suspension. Moryde makes a fantastic suspension upgrade kit. The heavy duty shackles and wet…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 10

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...