Will the Ultra-Fab Steel Rollers Work On a Dynamax Dynaquest XL Motorhome

Question

Question:

Can these handle the weight of a Super C? Dynamax Dynaquest XL 37BH in particular. I think this may be an option for us as our engine is up front and holding tanks are near the rear wheels. Heaviest element of our rig is the 150 gallon water tank under the bed in the rear.

asked by: Ed D

0

Expert Reply:

The Ultra-Fab Steel Jumbo Roller part # UF48-979023 is an excellent option to help prevent scraping on a motorhome when driving over bumps or uneven surfaces. In regards to installation, they will need to be welded to the frame, usually at the rear. There isn't any sort of listed weight capacity but so long as you don't have a diesel pusher motorhome with the engine in the rear you will be fine.

Therefore, I think they will work well for you since your engine is in the front of the motorhome.

expert reply by: Conner L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

view full answer...

Answer 8

The Kuat Sherpa 2.0 #SH22G and the NV 2.0 #NV22G that you referenced are both excellent platform-style racks that will hold your bikes by the front wheels with no frame contact. These are top-of-the-line carriers and you really would not go wrong…

view full answer...

Answer 9

The trailer hitch I recommend for a 2023 Hyundai Tucson is the Curt Trailer Hitch Receiver part #C94WR which I confirmed as a fit with Curt for all models, including the Hybrid. This trailer hitch features a bolt-on installation so there is no…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 12

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Will the Ultra-Fab Steel Rollers Work On a Dynamax Dynaquest XL Motorhome

Product Page this Question was Asked From

Continue Researching