Is Solera 12V XL Power RV Awning Available in Blue or Red

Question

Question:

Does this come in blue or red

asked by: Gina C

0

Expert Reply:

We do have some other colors for the Solera 12V XL Power RV Awning # LCV000335015-362241. For a Blue Fade fabric you'll want the kit # LC75FR, and then a Red fabric isn't manufactured but Lippert does offer it in Burgundy as part # LC65FR. Please note that the Awning Rail # LC715216 is also needed for this installation.

expert reply by: Jon G

0

Answer 1

In regards to the Solera 12V XL Power RV Awning part #LCV000335015-362241, the head of the support arm which is the furthest point out while closed will sit about 5-3/4" away from the side of the trailer.

view full answer...

Answer 2

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

view full answer...

Answer 3

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Answer 4

If your rear indicators are not working, it's almost certainly a poor ground, so the first thing to do is take a look at your ground connections to make sure they are attached to bare metal surfaces and free of any paint, dirt or corrosion. What…

view full answer...

Answer 5

A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…

view full answer...

Answer 6

Your 13-10 equalizers, which should be equivalent to Equalizer #TREQ310 measures 6-1/16 inches from bolt hole to bolt hole (see accompanying photo) and due to that you will need to use the E-Z Flex Heavy Duty Rubber Suspension System #K71-652-00.…

view full answer...

Answer 7

I've actually answered a similar question on this before and found: In my research I found that the grease seal you are looking for could have an inner diameter of either 2.24 or 2.12 inches and an outer diameter of 3.37 inches when measured with…

view full answer...

Answer 8

The correct replacement for the Oil Seal 225255UC is the Oil Seal part #9103309. These both have a 2.24/2.25" inner diameter and 3.37" outer diameter. They are also designed for use with oil bath hubs.

view full answer...

Answer 9

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...