Wiring Harness Needed To Install Replacement Motor for Stromberg Carlson Electric Landing Gear

Question

Question:

I purchased the LG-142178 from you and need the wiring harness kit. What is the part number?

asked by: Leonardo

0

Expert Reply:

The Replacement Motor for Stromberg Carlson Electric Landing Gear part # LG-142178 can be easily installed with the Replacement Switch for Stromberg Carlson Electric Landing Gear part # LG-145236.

expert reply by: Conner L

0

Answer 1

The 7-way trailer wiring format include an auxiliary 12V power circuit that is typically rated for 30 or 40-amps, depending on whether the install is factory or aftermarket. I checked the online manual for the 2016 Ram and page 841 indicates the…

view full answer...

Answer 2

While unlikely, it is certainly possible that the trailer battery could backfeed to your vehicle's battery when hooked up under the scenario you described. To make sure this doesn't happen all you need to do is add a single diode like the…

view full answer...

Answer 3

You will need a battery isolator, like Battery Isolation Solenoid, part #PK5231201, if you plan on leaving the trailer connected to the truck when the truck is off. If you unplug the 7-Way, the trailer battery cannot drain the truck battery. If you…

view full answer...

Answer 4

Lippert could not provide an RPM motor speed rating for this item but according to my contact there their replacement 5th Wheel RV Landing Gear Motor #LC142178 operates landing gear at a speed of 2-1/2-inches of lift per minute in single motor…

view full answer...

Answer 5

I can't help you with the power adapter for your older backup camera since we never carried that part, but I can help you make it so the tow vehicle you have won't continue to charge a trailer's battery when the vehicle is turned off to…

view full answer...

Answer 6

I was able to locate a wiring guide for jack motor switches such as your Atwood part and from these I linked a diagram for you. I also sent a link to a complete installation guide.

view full answer...

Answer 7

The vehicle battery will only provide a maintenance charge to the camper battery. It will not increase the camper battery charge level. When the camper connector is plugged into the vehicle, the vehicle's battery is supplying power to the camper,…

view full answer...

Answer 8

I would be happy to help! If the maintenance charge is enough for your battery, then running the #10-1-1 from the 12v accessory circuit of your 7-way connector to the positive terminal of your trailer's battery using a ring terminal #DW05705-1.…

view full answer...

Answer 9

You can put a maintenance charge on your trailer battery with the 12 volt accessory circuit of the 7-way. The 1:00 position of your 7-way carries this circuit. You would just need to run a length of 10 gauge wire like part #10-1-1 (sold by the foot),…

view full answer...

Answer 10

Check out the picture I attached that shows how the switch of the #LG-142178 wires to the motor and battery.

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Wiring Harness Needed To Install Replacement Motor for Stromberg Carlson Electric Landing Gear

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching