How to Order Replacement Nutsert and Tool for DeeZee Tailgate Assist # DZ43301

Question

Question:

How can I get one Nursery & tool

asked by: Albert L

0

Expert Reply:

I believe you are asking about ordering the nutsert and replacement tool for the DeeZee Tailgate Assist # DZ43301. The only way to get that is with the # BKT43301 that you referenced.

expert reply by: Jameson C

0

Answer 1

The blind nut you're speaking of that's used to install the DeeZee #DZ43301 tailgate assist works like a molly bolt. The portion of the bolt inside the tailgate mushrooms out, preventing the nut from pulling through. If it needs to…

view full answer...

Answer 2

I went and grabbed the nutsert of the #DZ43301 to measure it and it is .16 of an inch in diameter.

view full answer...

Answer 3

If the existing nutsert from DeeZee Tailgate Assist #DZ43301 is stripped out or is otherwise unable to come out then you may be able to gently pry it out some and then get some vise grips around it and pull it out. Otherwise it will likely have to…

view full answer...

Answer 4

To replace the ball mount bracket portion of the DeeZee Tailgate Assist #DZ43200 you can use part #BKT43200, which infludes the torx wrench, nutsert tool, and plate. The ball mount is not available by itself. I'm not quite sure why this piece…

view full answer...

Answer 5

I can certainly help you with that. Since the Curt T-Connector Vehicle Wiring Harness, part #C55384 is a 4-way connector the four functions will be Yellow for the left turn and brake, Green is for right turn and brake, Brown is for running lights,…

view full answer...

Answer 6

Looks like you overtightened the nutsert which stripped it out and rendered it unusable. You would need to order the part #BKT43301 and be careful not to strip out the new nutsert.

view full answer...

Answer 7

The clip that you are referring to that holds the 7-way plug to the socket is typically found on the connector which is why the #HM40940 does not come with it. I wish we sold that piece by itself but only way to get it is to go with a new harness…

view full answer...

Answer 8

If the hole on your tailgate happens to be on the passenger side there is no reason the DeeZee Tailgate Assist part #DZ43203 wouldn't work on that side as well. The install would then just be on the opposite side of the tailgate.

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...