Replacement Drive Head for Solera Hybrid RV Awning

Question

Question:

I have a solera hybrid awning and I need to replace the manual head Can I use this version?

asked by: Maurin J

0

Expert Reply:

The correct replacement drive head for the Solera Hybrid RV Awning is the Solera Manual Crank Style Awning Drive Head part # LC300031 for black or part # LC300029 for white.

expert reply by: Conner L

0

Answer 1

The length of your awning will not matter when using the Solera Manual Pull Style to Power Awning Conversion Kit #LC329251; there is not a separate kit for awnings of different sizes. This particular kit comes in black to match your awning. I've…

view full answer...

Answer 2

For your replacement the Ventline Ventadome Roof Vent w/ 12V Fan part #V2119-603-00 will do a great job for you. It will install in the same hole you currently have and it will use the remote that you currently have to operate it. I have attached a…

view full answer...

Answer 3

Yes, a weight distribution system like the Curt TruTrack Weight Distribution System part #C17499 will add stress to both the trailer and vehicle frame. That said, this stress is not usually enough to cause damage. The only exceptions to this would be…

view full answer...

Answer 4

Sounds like the driver head of your manual Solera awning is in need of replacing. For that we have the part #LC300031 which will replace what you have and allow you to roll yours up.

view full answer...

Answer 5

The gearbox inside of the Solera Manual Crank Style Awning Drive Head part #LC300031 is not available separately as a replacement part therefore if you need to replace this you will have choice but to replace the entire assembly.

view full answer...

Answer 6

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

view full answer...

Answer 7

The best solution we have for your situation is a new manual crank drive head for your Solera manual awning since the gears aren't available. For that you'd want the black drive head part #LC300031.

view full answer...

Answer 8

I have a solution for you, but my contact over at Lippert tells me that you won't be able to replace just those casings on Solera Slide-Out Topper. The parts you need are the Replacement Idler Head and Roll Tube for Solera RV Slide-Out Awning -…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Yes, you are going to also need the Demco Autoslide Capture Plates for Trailair Rota-Flex Pin Boxes #DM6171 when using the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040 with your Road Armor pin box. For a suspension enhancement I…

view full answer...