Replacement Crank Head for Manual Solera Awning

Question

Question:

I have a solera awning on my camper. Last year the latch to retract quit working. Was able to manually roll it up but I would like to repair it. What parts do I need. Its a 6ft awning. 19 ft wide

asked by: Teresa M

0

Expert Reply:

Sounds like the driver head of your manual Solera awning is in need of replacing. For that we have the part # LC300031 which will replace what you have and allow you to roll yours up.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The best solution we have for your situation is a new manual crank drive head for your Solera manual awning since the gears aren't available. For that you'd want the black drive head part #LC300031.

view full answer...

Answer 2

The gears alone cannot be replaced; you would need to replace the entire thing with the Drive Head for Solera Manual Crank-Style Awning #LC300031.

view full answer...

Answer 3

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack that…

view full answer...

Answer 4

The gearbox inside of the Solera Manual Crank Style Awning Drive Head part #LC300031 is not available separately as a replacement part therefore if you need to replace this you will have choice but to replace the entire assembly.

view full answer...

Answer 5

The length of your awning will not matter when using the Solera Manual Pull Style to Power Awning Conversion Kit #LC329251; there is not a separate kit for awnings of different sizes. This particular kit comes in black to match your awning. I've…

view full answer...

Answer 6

It sounds like you are referring to the Solera Manual Pull Style to Power Awning Conversion Kit part #LC329251 for black or part #LC337727 for white. The gears in either of these or the Solera Manual Crank Style Awning Drive Head part #LC300031 for…

view full answer...

Answer 7

Yes, a weight distribution system like the Curt TruTrack Weight Distribution System part #C17499 will add stress to both the trailer and vehicle frame. That said, this stress is not usually enough to cause damage. The only exceptions to this would be…

view full answer...

Answer 8

For your replacement the Ventline Ventadome Roof Vent w/ 12V Fan part #V2119-603-00 will do a great job for you. It will install in the same hole you currently have and it will use the remote that you currently have to operate it. I have attached a…

view full answer...

Answer 9

The correct replacement drive head for the Solera Hybrid RV Awning is the Solera Manual Crank Style Awning Drive Head part #LC300031 for black or part #LC300029 for white.

view full answer...

Answer 10

The electric Solera awnings don't use locks to keep them held in place as the motors of them keep them from unrolling. The locks are only needed with the manual awnings like what the #LC362101 provides.

view full answer...

Answer 11

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

view full answer...

Answer 12

I contacted Lippert to ensure the correct item, thanks for attaching the image of the tag on your specific awning. We now have the Vista Light LED Kit for Solera RV Awning, #LC24PJ, available that is a direct replacement to your component.

view full answer...

Replacement Crank Head for Manual Solera Awning

Product Page this Question was Asked From

Continue Researching