Replacement Gearbox for Solera Manual Crank Style Awning Drive Head LC300031

Question

Question:

All i need is the gearbox that’s inside the 300031, is that available? Dang shame to have to buy the entire thing.

asked by: Brian

0

Expert Reply:

The gearbox inside of the Solera Manual Crank Style Awning Drive Head part # LC300031 is not available separately as a replacement part therefore if you need to replace this you will have choice but to replace the entire assembly.

expert reply by: Conner L

0

click to enlarge

Answer 1

Yes, you could convert your Solera power awning to a manual crank awning with the Crank Awning Conversion kit part #LC333411. This kit normally converts a pull style awning to power but will work great for your application as well.

view full answer...

Answer 2

It is totally possible to convert your manual pull awning out to a manual crank awning! All you need is a conversion kit which we have in White #LC333410 or Black #LC333411 to match your current setup. Attached is a review video for you to check…

view full answer...

Answer 3

The electric Solera awnings don't use locks to keep them held in place as the motors of them keep them from unrolling. The locks are only needed with the manual awnings like what the #LC362101 provides.

view full answer...

Answer 4

Sounds like the driver head of your manual Solera awning is in need of replacing. For that we have the part #LC300031 which will replace what you have and allow you to roll yours up.

view full answer...

Answer 5

The best solution we have for your situation is a new manual crank drive head for your Solera manual awning since the gears aren't available. For that you'd want the black drive head part #LC300031.

view full answer...

Answer 6

The gears alone cannot be replaced; you would need to replace the entire thing with the Drive Head for Solera Manual Crank-Style Awning #LC300031.

view full answer...

Answer 7

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack that…

view full answer...

Answer 8

You'll need to chose a jack whose capacity is greater than the fully loaded and ready to tow tongue weight of the camper. Going with a powered jack whose capacity is much greater than the tongue weight of the camper is recommended because the…

view full answer...

Replacement Gearbox for Solera Manual Crank Style Awning Drive Head LC300031

Product Page this Question was Asked From

Continue Researching