Hardware to Install the Horse Trailer Side Pad

Question

Question:

does this come with the hardware to install

asked by: Sandi

0

Expert Reply:

The Horse Trailer Side Pad - 60" # HTP1260BK does not come with the hardware needed to install, although we do carry it.

All you need is the Trailer Horse Pad Screw # PS-8 and you're set. The screws will install around the edges of the pad to secure it.

expert reply by: Kyle S

0

Answer 1

We have added the 60" X 12" Pad #HTP1260BK since the particular answer page you found was made. We do have the 40" X 9" Pad #HTP40BK and 60" X 9" Pad #HTP60BK. These are all made by Redline with Redneck Trailer Supply…

view full answer...

Answer 2

It really is up to you to decide how many pad screws to use to install the Horse Trailer Side Pad #HTP60BK that you referenced, but typically customers use between 12 and 16 screws. The part number for the screws is PS-8.

view full answer...

Answer 3

The PS-8 screws should work very well going into either material you mentioned. The threads are coarse enough that they'll get good hold on the aluminum or the rubber. For best results, you'll want to ensure that as many screws as possible go…

view full answer...

Answer 4

The Horse Trailer Side Pad - 60" #HTP1260BK will allow you to remove staples from the cardboard backing and wrap the cover around plywood as you referenced. You will simply want to be careful in removing the staples so you don't damage the…

view full answer...

Answer 5

In order to install the the Horse Trailer Side Pad - 60" #HTP1260BK you just need to screw them in. What you'll need are the Trailer Horse Pad Screw #PS-8 and attach them to the sides of the pad.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...