Recommended Trailer Hitch For 2016 Kia Soul EV Model

Question

Question:

Do you have one? 2016 Kia Soul Battery Electric! 1 1/4 receiver hitch.

asked by: Ormond O

1

Helpful Expert Reply:

I believe you are asking for a 1-1/4" hitch for the 2016 Kia Soul. I recommend Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit part # 24915 which is designed for all models of the Kia Soul even the EV model and has a 1-1/4" receiver. I have attached an installation video for your reference. This will give you a Class I 1-1/4" hitch on the back of the Kia Soul.

expert reply by: Heather A

1

Answer 1

For carrying a bike rack the best hitch for your 2016 Kia Soul is the Draw Tite hitch part #24915. The advantage the Draw Tite has over the Curt is that it does not require a stabilizer strap like part #18050 when carrying a non-supported load like a…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

It looks as if your hitch crossbar has been drilled into and riveted into place which is a BIG TIME no-no. The people that installed it should have known better as drilling into a hitch can weaken it's structural integrity. To remove the trailer…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 7

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...