Can The Lippert Replacement Legs be Used Independently From Ground Control System?

Question

Question:

Can the replacement jack be used independently with a switch if i would buy a right and left jack

asked by: Michael A

0

Expert Reply:

Yes. If you were to wire the power and ground wires on the Replacement Legs # LC305339 and # LC344792 to a switch similar to the Replacement Power Switch # LC144214 you would be able to use them independently of a Lippert Ground Control system # LC358590 . The only issue you'll encounter is that they will not automatically level themselves since that is handled via signals to the control module.

expert reply by: Erik B

0

Answer 1

The Ground Control jacks for travel trailers are different as they are a C-jack instead of a vertical lift. I recommend using the Replacement C-Jack for Lippert Components Electric Ground Control TT #LC404488 for that application instead of…

view full answer...

Answer 2

I attached a dimension picture I got from Lippert for the Replacement I-Beam Jack Bracket #LC349975 that you referenced.

view full answer...

Answer 3

If you have a Lippert Ground Control leveling system on your 2016 Jayco trailer then Replacement Left Rear Leg for Lippert Components Ground Control 3.0 Electric Leveling System Item #LC305339 is the correct replacement. If it is a different brand…

view full answer...

Answer 4

We do have motors that you can add to your landing gear. For example, the Landing Gear Set #RVLG-8000 can be operated with the manual crank #RVLG-HDL but you can also add the motor #LC142178 and switch #LG-145236 for effortless operation on your…

view full answer...

Answer 5

I have a couple of solutions but after contacting lippert I have found the female plug end for the Replacement Short Left Rear Leg - Ground Control 3.0 Electric Leveling System part #LC342610 is not something available separately. Solution One will…

view full answer...

Answer 6

There will be 4 wires coming from the Lippert Replacement Electric Jack Switch #LC387874 that you are looking at. The blue wire from the switch will go to a 6 amp breaker like #LC134181 that is installed between the switch and jack motor. This will…

view full answer...

Answer 7

The difference between the Replacement Left Rear Leg for Lippert Components Ground Control 3.0 part #LC305339 and the Replacement Right Rear Leg for Lippert Components Ground Control 3.0 part #LC344792 is the side of the jack that the mounting…

view full answer...

Answer 8

I do have a solution for you, but unfortunately there are no replacement legs for your stabilizer jack 113407 and you will need to replace the whole unit. I confirmed this with my contact at Lippert. The correct replacement for your jack is the…

view full answer...

Answer 9

The overall height of the mounting plate of the Replacement I-Beam Jack Bracket for Lippert Ground Control #LC349975 is 13 inches.

view full answer...

Answer 10

Yes it does, what you will need are 1/2"-20 self-tapping bolts in order to install the bracket you asked about: - Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 #LC349975

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...