Can I Remove Hand Winch From Brophy Cable Camper Jack CJ74H For Storage

Question

Question:

Hello, Is it possible to remove the pulley bolt for smaller breakdown and storage? If so do you knownwhat kind of bolt that is?

asked by: Zach

0

Expert Reply:

The Brophy Cable Camper Jack part # CJ74H does break down into 3 pieces for storage however the pully portion of the Camper Jack (winch) is not removable because it is welded on. I have attached a photo of the camper jack disassembled.

expert reply by: Heather A

0

click to enlarge

Erik F.

6/18/2020

Are they 1500lb each or both?

Reply

Chris R.

6/22/2020

The Brophy Cable Camper Jack # CJ74H has an individual capacity of 1,500 pounds. So two of the jacks together would combine to provide a 3,000 pound limit.

Reply

Answer 1

The best replacement option we offer for a Micro-Flex 349 Trailer Clearance Light is the Trailer Clearance or Side Marker Light part #MC32AB which is not the exact same shape but very similar and almost the same size. It also uses the same mounting…

view full answer...

Answer 2

If the lights you want to replace are stop, turn, tail light, and back up lights, then part #30-92-002 and part #30-92-004 would work for you. I have attached a drawing that shows the dimensions of the two lights mentioned above. These lights…

view full answer...

Answer 3

The combined weight capacity of the Brophy Cable Camper Jacks #CJ31 is 1,000 lbs. I have linked the above mentioned product to this page for your purchasing convenience.

view full answer...

Answer 4

We have excellent options for replacing your truck bed camper jacks but we do not have a way to get the gears you'd need for the jacks that you currently have. Based on that you'd want the Brophy Cable Camper Jacks #CJ31 which has a…

view full answer...

Answer 5

The best priced pair of camper jacks we offer is the part #CJ31. If you needed a total of 4 of these jacks you'd need to order a quantity of 2 of these.

view full answer...

Answer 6

Hey Jonathan, it's odd but the Happijac Extender Bracket part #HJ54FR does not come with mounting hardware. You'd basically need to take the current hardware from your setup to a hardware store so you can get a duplicate bolt and nut…

view full answer...

Answer 7

If you're looking for just the L-bracket for your HappiJac Electric Truck Camper Jack System #LC736514-ELKIT then you'll need part #LC182492. The flat bracket can be swapped out with part #LC182494 and the swing brackets can be…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 10

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is…

view full answer...

Can I Remove Hand Winch From Brophy Cable Camper Jack CJ74H For Storage

Product Page this Question was Asked From

Continue Researching