Distance Between the Wheel and Frame on a 2000 Dodge Ram with Firestone Air Springs Installed

Question

Question:

how much clerance between wheel and frame

asked by: Sonja

0

Expert Reply:

The Firestone suspension system, # F2071, installs directly over the leaf springs on the axle of the truck and directly below the frame rails. The brackets overhang the spring and frame by about 1/2 inch as you can see in the instructions I have linked for you. I have also included a link to a video showing a typical installation which will give you a better idea of how the system installs.

expert reply by: Michael H

0

Answer 1

I went out to the warehouse and pulled a Firestone Ride-Rite system #F2071. When fully collapsed and no air in the system it measures 2-3/4 inches not counting the valves on the top. Please note that you should always have at least 5 psi in the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 8

Although the Tekonsha Prodigy P3 #90195 and Primus IQ #TK90160 electric brake controllers are very similar they do have some key differences as well. For one the P3 is designed to work with electric and electric over hydraulic brake systems. The…

view full answer...

Answer 9

Hellwig lists the Hellwig Rear Anti-Sway Bar #HE36MR as the correct fit for a 1998 Chevy K2500. As for fitment with the staggered shocks, you shouldn't have any issues and can even see this setup in the attached installation picture below. The…

view full answer...

Answer 10

Hey David, actually what is going to make the biggest improvement in handling and stability for your 2011 Itasca is an upgraded rear sway bar with the part #RM-1139-175. I know that's not what you asked about but for motorhomes where most of the…

view full answer...

Answer 11

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 12

I did a little research on your 2001 Dodge Ram 3500 and found that it's max towing capacity is listed as 13,900 lbs. I would strongly recommend you check the owners manual of your truck to see what Dodge lists as the capacity for your truck and…

view full answer...