Are the Fuse Taps Required To Install the Air Lift WirelessAIR Compressor System Part # AL74000

Question

Question:

Do I have to use the fuse adapter with the compressor wiring? I plugged into an used fuse prong that that is hot only when the ignition is on. Is this acceptable?

asked by: Jim S

0

Expert Reply:

The fuse adapter that is included with the Air Lift WirelessAIR Compressor System part # AL74000 is optional therefore, it does not have to be used. However, you will need to run the power wire from the compressor relay directly to an un-fused side of the ignition. If this is what you are tied into now then you are good to go. The complete instructions for the above kit are attached for you as well.

expert reply by: Conner L

0

Answer 1

Sounds like your air bag setup has a slow leak that is causing the compressor system to try and keep up too often. You should take some soapy water and spray on the bag, lines and where it connects to the Air Lift Compressor part #AL74000 to see if…

view full answer...

Answer 2

We can definitely help set you up with air bags and a wireless compressor for your 2024 Chevy Silverado 2500 4WD long bed. Lets get right into it. For an air bag kit I recommend the Firestone Ride-Rite Air Helper Springs #F2613. I like the Firestone…

view full answer...

Answer 3

It sounds like the compressor system may not be getting power or is not waking up. Depending on how the Air Lift WirelessONE Compressor System #AL25980 is wired to your vehicle you may have to do additional steps. The wiring harness has a ignition…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

Hey Dustin, thanks for reaching out! I will recommend SumoSprings over Timbrens all day everyday because they are much more forgiving when the vehicle is unloaded. We've actually joked around here about how the Timbren kits will either give you…

view full answer...

Answer 12

I recommend going with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL89DQ for hauling around an in-bed camper with your 2024 Ford F-350 Super Duty. I really like this kit because it has the higher 7,500 lb rating (which you don't…

view full answer...

Are the Fuse Taps Required To Install the Air Lift WirelessAIR Compressor System Part # AL74000

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching