Recommended Stabilizer Jacks for 2011 Open Range Journeyer 340FLR

Question

Question:

Thanks for response on my Tongue Jack but now I have issues with my Stabilizer Jacks, two have rusted and broken, havent messed with the other two but I am sure of the same thing. Which Stabilizer Jack do you recommend. The type I have are like landing legs. Any guidance would be greatly appreciated. The spec are as follows: 2011 Open Range 340flr Journeyer: Dry Weight 8,860 lbs. Payload Capacity 2,810 lbs. GVWR 11,670 lbs. Hitch Weight 1,270 lbs.

asked by: Manuel V

0

Expert Reply:

For your 2011 Open Range Journeyer 340FLR, I recommend the Ultra-Fab Ultra Scissor Jacks - 30" Lift - 6,500 lbs - Qty 2 # UF48-979031 or the 24 inch lift # UF48-979002. These manual jacks will provide excellent support and you can even use the drill attachment # UF48-979005 to make it easier to extend and retract. I've attached a photo to help with mounting hole spacing.

If you are looking for powered jacks, then I recommend the Lippert Components High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift # LC298707. These jacks are used as standard equipment on many campers and work very well. They give you the ability to simply use a button and your trailer battery to extend and retract your jacks. One is needed for the front and one for the rear. You can of course add them in stages if desired.

expert reply by: Jason S

0

click to enlarge

Answer 1

Sounds like the panic stop you had to do with your Ground Control 2.0 possibly caused an internal bug on your system. We've spoken with Lippert in the past about resetting the GC systems and they have told us that you need to cut the power…

view full answer...

Answer 2

In order to replace your Carrier Air V RV Air Conditioner I highly recommend using the Advent Air Replacement RV Air Conditioner for Carrier Setup part #ACCAR150 for 13,500 Btu's or part #ACCAR135 for 15,000 Btu's. This unit will be the only…

view full answer...

Answer 3

The pin weight of a fifth wheel trailer is normally right at 20 percent of the total trailer weight. If your trailer weighs 14,370 lbs it would have a pin weight around 2,874 lbs which would easily be compatible with the Ultra Fab Landing Gear kit…

view full answer...

Answer 4

We have exactly what you need to replace your Carrier air conditioner with an AC with heat pump. The Advent RV Air Conditioner has an adapter wiring kit so you do not have to re-wire your entire AC unit, it is compatible with your Carrier thermostat…

view full answer...

Answer 5

Yes, we do have a direct replacement for your Carrier Air V Rooftop Air Conditioner, the Advent Air Replacement RV Air Conditioner for Carrier Setup part #ACCAR150 for white or part #ACCAR150B for black. These units are both 12-13/16" tall which…

view full answer...

Answer 6

I have attached a drawing of the #UF17-943010 jack you can check out. The dimensions are shown and you can see if the stops on the trailer match those dimensions on the jack. That would be the biggest concern for a fit. If you find the dimension is…

view full answer...

Answer 7

The Carrier Air V RV Air Conditioner is no longer produced so a direct replacement of the same unit is not an option. However, we do have available the two Advent AC models that are designed as replacement units for the Carrier Air V. I recommend…

view full answer...

Answer 8

Carrier is no longer making RV AC units but I do have a solution. You can use the Advent Air RV Air Conditioner - 13,500 Btu - Black #ACM135B. You will also need the Carrier Adapter Wiring Kit for Advent Air RV Air Conditioners #ACCARKIT for…

view full answer...

Answer 9

The Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs #UF17-943010 is not designed for boat trailers, but will easily do the job. Unfortunately, the jack will pull too much power for your trailer connector to be utilized without…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Tim, so the Ultra Fab Landing Gear part #UF17-943010 does use a more unusual weld stop dimension as it's 20-1/4 inches from outside to outside of the it's weld stops. So since it looks like you already ordered this you can still make it…

view full answer...

Recommended Stabilizer Jacks for 2011 Open Range Journeyer 340FLR

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching