Could Ultra Fab Landing Gear Jacks Fit 2018 Jayco 29.5BHOK
Question:
Have a 2018 Jayco 29.5bhok. Can I bolt this jack right to it?
asked by: Tim
0
Expert Reply:
Hey Tim, so the Ultra Fab Landing Gear part # UF17-943010 does use a more unusual weld stop dimension as it's 20-1/4 inches from outside to outside of the it's weld stops. So since it looks like you already ordered this you can still make it work worse case scenario as you could have the brackets on your trailer moved and rewelded.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Complete AC System With An Advent 13.5K BTU Low Profile AC Unit
- Q&A: Correct Replacement for Atwood 71119 Landing Gear Motor
- Q&A: Diameter of Replacement Hinge Pin # 362TRCHingePin2
- Q&A: Atwood 87701 landing gear switch replacement
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Q&A: Recommendation for Replacing Bevel Gears for Atwood Landing Gear or Replacing Entire Landing Gear
- Q&A: What Does Code L. Mean on Curt Triflex Brake Controller
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How Much Solar Power Do I Need For My RV?
- Article: Does Solar Panel Type Really Matter?
- Article: Trailer Tire Sizing