Troubleshooting of JT's Strongarm Adapter that's too Wide to Install

Question

Question:

The lippert adapter lugs part# 314592 is too thick to fit into my it strong arm arm. Part # 191023 Am I just doing something wrong?

asked by: Tyler H

0

Expert Reply:

The other end of the JT's Strongarm part # LC191023 has a wider lug spacing to allow the # LC191023 to install into. You are trying to install the kit on the end that is narrower.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Can you send me a picture of the feet of your jacks? How far apart are they?

view full answer...

Answer 2

Thank you for your purchase from etrailer of the JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ 58" or More Between Landing Gear #LC191023. The orientation does not need to be chanced it is just rearranging the bars like…

view full answer...

Answer 3

For your 2019 Jayco Jay Flight 32BHDS with heated underbelly, the JT's Strong Arm Jack Stabilizer Kit for Travel Trailers #LC191025 will fit and give you the stabilization you are seeking. The enclosed underbelly will not hinder the fit in…

view full answer...

Answer 4

Two of the bars that come with the JT's Strong Arm Jack Stabilizer Kit for Travel Trailers #LC191025 install on the front landing gear legs like you can see in the attached picture and install video link on this page and the other two install…

view full answer...

Answer 5

Since you have electric stabilizers on your RV you would only use 4 of the arms that come with the part #LC191025. If you check out the install instructions link I attached you can see that your setup is shown in figure 3.

view full answer...

Answer 6

I went our to the warehouse to measure the eye to eye distance on the arms of the JT's Strong Arm Jack Stabilizer Travel Trailer Kit #LC191025. From the center of one eye to the center of the other it was exactly 26 inches.

view full answer...

Answer 7

For attaching the JT's Strong Arm Jack Stabilizer Kit #LC191023 to front landing gear the needed brackets are included. I attached a picture that shows how these install to landing gear jacks on the front of a trailer as well as an install…

view full answer...

Answer 8

The placement for the rear stabilizer from the JT's Strong Arm Jack Stabilizer Kit #LC191023 can vary from camper to camper as they are not always the exact same sub structure under the frame. I have linked a copy of the installation instruction…

view full answer...

Answer 9

To select your correct JT's Strong Arm stabilizer kit for your 2017 Montana 3950BR 5th wheel you will want to measure the distance between your landing gear legs. If less than 58-inches use kit #LC191024 or kit #LC191023 if there is more than…

view full answer...

Answer 10

Since you have 85-1/2" between the legs of your landing gear the correct JT's Strong Arm Jack Stabilizer Kit is #LC191023. Prices do fluctuate so you can find the current price on the linked product page.

view full answer...

Answer 11

I recommend the MORryde 5th Wheel Cross Brace Landing Gear Stabilizer, #MR72AR that permanently attaches to your fifth wheel's landing gear reducing movement while parked. After installation, the braces will extend and retract with your landing…

view full answer...

Answer 12

Yes, the MORryde 5th Wheel Cross Brace Landing Gear Stabilizer item #MR72AR is universal and will fit your 2022 Grand Design Reflection 150 295rl so long as your landing gear is between 58"-80" wide.

view full answer...