Troubleshooting Trailer Turn Signal and Brake Lights not Functioning
Question:
I have power at pigtail but no turn signal or break lights
asked by: Michael W
Expert Reply:
Typically this problem is caused by a blown trailer wiring fuse on the vehicle. Or just dirt or corrosion on the connectors that need to be cleaned off. Or it can be a bad or weak ground on the trailer wiring.
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester like # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.
Products Referenced in This Question
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Shop: Curt Relay Kit for Nissan Armada or Titan Aftermarket Tow Package
- Article: Trailer Wiring Diagrams
- Q&A: Working Running Lights, But No Turn Signals or Brake Lights On Trailer
- Q&A: Troubleshooting Trailer Brake Lights Not Functioning
- Shop: Hook Probe Circuit Tester
- Search Results: equalizer
- Shop: Trailer Wiring
- Q&A: Install Instructions Link for Lippert Lift Kit # LC382741
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Shop: Trailer Hitch
- Video: Choosing the Right Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 25580
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Roadmaster Active Suspension Leaf Spring Kit Review
- Shop: Brake Controller
- Search Results: hubs
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Shop: Suspension Enhancement
- Search Results: 44649
- Video: Dexter Axle Trailer Axles K71-707-01 Review
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: Replacement for Demco Master Cylinder 05680-C for Drum Brakes
- Shop: Fifth Wheel Hitch
- Article: Where to Position the Trailer Axle?
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional