What is the Mounting Hole Spacing for the CURT Trailer Hitch # C14355

Question

Question:

What is the center to center of holes across and front to back ??

asked by: Ed E

0

Expert Reply:

I spoke with my contact at CURT about Trailer Hitch # C14355. From side to side, the holes that would be furthest forward on the truck are 34 inches apart on center. The 2 sets that are at the end of the hitch are 33-11/16 inches apart on center.

Front to back, the two closest holes are just a hair under 2-1/2 inches apart on center. From the middle hole to the furthest away hole on center it is just a hair over 11-1/8 inches.

I have included a link to the installation instructions for this hitch for you to view.

expert reply by: Michael H

0

click to enlarge

Answer 1

The only differences in the 3 Curt Trailer Hitch Receivers #13355, #C13038 and #13359 for your 1999 Ford F-150 XL Flairside, is the construction and shape of the receiver cross tube and mounting plates. Of these 3 I would choose the Receiver #C13038.…

view full answer...

Answer 2

I had our warehouse measure the Curt Trailer Hitch Receiver #13359 you were looking at and it measures 33-1/2" wide from the center of the left bolt hole to the center of the right bolt hole as shown in the included diagram. I included a link to…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 6

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...