Draw-Tite Receiver Location Relative to Rear Bumper of 2009 Hyundai Elantra
Question:
need to see how far from bumper the hitch protrudes past bumper on an 09 elantra touring so I can get the size receiver i would like to order with hitch,thanks
asked by: Todd L
Expert Reply:
I do have some information for you but unfortunately we haven't had the chance to install the Draw-Tite Sportframe Trailer Hitch Receiver # 24844 on a 2009 Hyundai Elantra so we don't have a video for you that shows the where the receiver sits in relation to the bumper.
Aside from the linked installation instructions I went out to the warehouse and found that from the rearmost mounting hole to the end of the receiver opening measured about 10". The center of the hitch pin hole is further back about 2" so that means that measurement is reduced to 8" if that is what you were needing. I have attached a photo to demonstrate these measurements for you.
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Draw-Tite Drawbar for 1-1/4" Hitches - 4" Rise - 10" Long - 2,000 lbs
- Shop: Trailer Wiring
- Video: Trailer Hitch Installation - 2012 Hyundai Elantra - Curt C11303
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Q&A: Can Kuat NV 2.0 4 Bike Rack NV22G-NA22G Be Used With Bikes That Have Fenders?
- Shop: Replacement Anti-Sway Attachment for Thule Apex and Helium Aero Bike Racks - Qty 1
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Does the Kuat NV 2.0 Work with Bikes with Fenders?
- Q&A: Differences Between Kuat Sherpa 2.0 and NV 2.0 Bike Racks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: 68149
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Article: Trailer Wiring Diagrams
- Shop: Suspension Enhancement
- Search Results: 25580
- Video: Choosing the Right Brake Controller
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Search Results: dust cap
- Video: Lippert Solera Slider Slide-Topper Review
- Shop: Brake Controller
- Article: My Trailer Hitch Doesn't Fit
