Will the Buyers Products 8 Ton Combination Hitch Work with the B&W Pintle Hook Mounting Plate

Question

Question:

Bwpmhd14005 will this hitch hook up to buyers pintle hook 33710055

asked by: John

1

Helpful Expert Reply:

Yes, the B&W Pintle Hook Mounting Plate part # BWPMHD14005 and the Buyers Products 8 Ton Combination Hitch with Mounting Kit part # 33710055 will work with one another as they both have mounting holes spaced 1-3/4" apart on center vertically and 3-3/8" apart on center horizontally.

expert reply by: Conner L

1

Answer 1

Yes the Curt Pintle Hook #C48215 will bolt up perfectly to the B&W Pintle Hook Mounting Plate for 2" Hitches #BWPMHD14005 you were looking at. This will give you 6 different positions to mount the pintle hook so you can make sure your…

view full answer...

Answer 2

The B&W Pintle Hook Mounting Plate part #BWPMHD14005 that you referenced will slide into a 2" receiver tube opening on the tow vehicle. This will then accept a pintle hook so that you can tow a trailer with a lunette ring, not the other way…

view full answer...

Answer 3

For your 2006 Jeep Liberty Renegade, I recommend using the Convert-A-Ball Pintle Hook Combo with 3 Stainless Steel Balls - Bolt On - 25,000 lbs #PH1. This will give you all 3 of the hitch ball sizes and also give you the pintle hook option. For the…

view full answer...

Answer 4

You are pretty well balanced but given that the axles are the fulcrum (if you think of the trailer as a teeter totter) you have more weight on the long side. If you swap the positions of the Arctic Cat and the Honda/Timberwolf it would be a better…

view full answer...

Answer 5

Yes the B&W Pintle Hook Mounting Plate #BWPMHD14005 can absolutely be used in the rise position to raise the height of your pintle hook. This mounting plate fits 2" hitches, has a 15" shank and mounting holes that measure 3-3/8"…

view full answer...

Answer 6

There's no reason you couldn't use the B&W Pintle Hook Mounting Plate #BWPMHD14005 in both the rise and drop configuration. For a pintle hook to go along with it you might also be interested in the Pintle Hook part #C48210.

view full answer...

Answer 7

Yes, you can bolt pintle hook #C48210 to B&W Pintle Hook Mounting Plate #BWPMHD14005. However, the capacity of the mounting plate is 16,000 pounds so that is the maximum capacity of this set up even though the pintle hook is rated higher. You…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...